Characterization of nanoscale precipitates and enhanced mechanical properties of high strength weld metals containing Cu additions after PWHT
Authors:
- 16 February 2022
- journal article
- research article
- Published by EDP Sciences in Metallurgical Research & Technology
- Vol. 119 (1) , 119
Abstract
In order to match rapidly development of high strength low alloy steels, the new metal cored wire contained copper was designed. The multi-pass weld metals were obtained by gas metal arc welding. Results show that microstructure of weld metals is bainite with M-A constituents, and there are nano-9RCu precipitates after PWHT. The weld metal as welded achieves 737 MPa of yield strength (YS) and 1097 MPa of ultimate tensile strength (UTS), with an elongation 8%. After PWHT, the YS and UTS are 725 MPa and 968 MPa, respectively, and elongation increases to 16%. The lower dislocations density and reduction of Cu element at solid solution state hence for the decrease of YS. As well, the nano-Cu precipitates and reduction of effective grain size make it increase. The combined effect of these factors makes YS decrease by only 12 MPa after PWHT. Besides, a good impact performance (46.6 J) can be obtained after PWHT, while it is only 27.7 J of weld metals as welded. The improved toughness of weld metals after PWHT is obtained by the contributions of finer effective grain size, soft bainite, and dispersed nano-9RCu precipitation. The nano-Cu precipitates can improve strength without damage to toughness of weld metal after PWHT.Keywords
This publication has 38 references indexed in Scilit:
- High-pressure torsion of pure metals: Influence of atomic bond parameters and stacking fault energy on grain size and correlation with hardnessActa Materialia, 2011
- Comparison of the Dislocation Density in Martensitic Steels Evaluated by Some X-ray Diffraction MethodsISIJ International, 2010
- Flux-cored wires for arc welding and surfacing of cast ironWelding International, 2008
- Evidence for deformation-induced transformations of Cu-rich precipitates in an aged FeCu alloyPhilosophical Magazine Letters, 2006
- Interfacial segregation at Cu-rich precipitates in a high-strength low-carbon steel studied on a sub-nanometer scaleActa Materialia, 2006
- Origin of copper precipitation strengthening in steel revisitedScripta Materialia, 2005
- Atomistic study of the coherency loss during the B.C.C.–9R transformation of small copper precipitates in ferritic steelsActa Materialia, 2001
- Martensite in steel: strength and structureMaterials Science and Engineering: A, 1999
- Microstructure of copper-bearing CMn weld metal: As-welded and stress-relieved statesMaterials Science and Engineering: A, 1990
- Second Phases in SteelScience, 1977