Dispersion-Free Solvent Extraction of Cr(VI) from Acidic Solutions Using Hollow Fiber Contactor
- 11 September 2009
- journal article
- research article
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 43 (20) , 7718-7722
Abstract
The use of dispersión-free solvent extraction, through microporous hydrophobic membrane has been investigated. The hollow fiber contactor, with surface area of 1.4 m2 was used to extract Cr(VI) (0.005−0.12 g/L) from aqueous sulphuric acidic media (pH 2.5−4.2 ± 0.05). Several parameters such as extractant concentration, feed acidity and metal concentration in the initial aqueous solution were investigated. Results revealed that 15% v/v Cyanex 923 in Exxsol D-100 as organic phase and feed in the 2.5 pH range, gave optimum extraction (exceeding 95%) of Cr(VI) and it was possible to strip using 10 g/L hydrazine sulfate (also with recoveries exceeding 95%). In this step, Cr(VI) is immediately reduced to the less hazardous Cr(III) state. Results also showed that under the various experimental conditions, chromium(VI) extraction was rate-controlled by the interfacial reaction on the membrane surface. Typical overall mass transfer coefficients values are 4.2 × 10−5 and 3.6 × 10−6 cm/s for extraction and stripping operations, respectively.Keywords
This publication has 11 references indexed in Scilit:
- Modeling of Effect of pH on Mass Transfer of Copper(II) Extraction by Hollow Fiber Renewal Liquid MembraneIndustrial & Engineering Chemistry Research, 2008
- Uphill permeation of Cr(VI) using Hostarex A327 as ionophore by membrane-solvent extraction processingChemosphere, 2008
- Pseudo‐emulsion based hollow fiber strip dispersion: A novel methodology for gold recoveryAIChE Journal, 2007
- Recycling of Cr(VI) by membrane solvent extraction: Long term performance with the mathematical modelChemical Engineering Journal, 2006
- Membrane processes for the efficient recovery of anionic pollutantsDesalination, 2006
- Removal and recovery of Cr(VI) from polluted ground waters: A comparative study of ion-exchange technologiesWater Research, 2005
- Comparative performance of non-dispersive solvent extraction using a single module and the integrated membrane process with two hollow fiber contactorsJournal of Membrane Science, 2004
- Analysis of liquid membrane extraction of binary Zn(II) and Cd(II) from chloride media with Aliquat 336 based on thermodynamic equilibrium modelsJournal of Membrane Science, 2004
- Strontium Removal by New Alkyl Phenylphosphonic Acids in Supported Liquid Membranes with Strip DispersionIndustrial & Engineering Chemistry Research, 2002
- The phosphine oxides Cyanex 923 and Cyanex 925 as extractants for gold(I) cyanide aqueous solutionsHydrometallurgy, 1994