A new electronic feedback compensation method for rate integrating gyroscopes
- 1 February 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 9-12
Abstract
Towards the objective of a rate integrating gyroscope (RIG) without a minimum rate threshold and performance limited only by electrical and mechanical thermal noise, we present our progress on a new, generalized electronic feedback method for the compensation of resonator damping asymmetry (anisodamping) and stiffness asymmetry (anisoelasticity) with a new method of RIG operation using self-precession. This enables overcoming the precession angle-dependent bias error and minimum rate threshold, two issues identified by Lynch for a MEMS RIG [1]. To correct angle-dependent bias, we augment the electronic feedback force of the amplitude regulator with a non-unity gain output distribution matrix selected to correct for anisodamping. Using this method, we have decreased the angle dependent bias error by a factor of 30, resulting a minimum rate threshold of 3.5 dps. To further improve RIG performance, an electronically-induced self-precession rate is incorporated and successfully demonstrated to lower the rate threshold. The RIG's output noise is also evaluated, demonstrating an ARW of 11 mdps/√Hz, similar to rate gyro operation at same amplitude.Keywords
This publication has 5 references indexed in Scilit:
- Epitaxially-encapsulated quad mass gyroscope with nonlinearity compensation2016
- Control and damping imperfection compensation for a rate integrating MEMS gyroscope2015
- Disk resonator gyroscope with whole-angle mode operation2015
- Silicon MEMS Disk Resonator Gyroscope With an Integrated CMOS Analog Front-EndIEEE Sensors Journal, 2014
- MRIG frequency mismatch and quadrature control2014