ACL Fibers Near the Lateral Intercondylar Ridge Are the Most Load Bearing During Stability Examinations and Isometric Through Passive Flexion
Authors:
- Danyal H. NawabiDNDanyal H. Nawabi
- Joseph T. NguyenJNJoseph T. Nguyen
- 28 July 2016
- journal article
- Published by SAGE Publications in The American Journal of Sports Medicine
- Vol. 44 (10) , 2563-2571
Abstract
Background: The femoral insertion of the anterior cruciate ligament (ACL) has direct and indirect fiber types located within the respective high (anterior) and low (posterior) regions of the femoral footprint. Hypothesis: The fibers in the high region of the ACL footprint carry more force and are more isometric than the fibers in the low region of the ACL footprint. Study Design: Controlled laboratory study. Methods: Ten fresh-frozen cadaveric knees were mounted to a robotic manipulator. A 134-N anterior force at 30° and 90° of flexion and combined valgus (8 N·m) and internal (4 N·m) rotation torques at 15° of flexion were applied simulating tests of anterior and rotatory stability. The ACL was sectioned at the femoral footprint by detaching either the higher band of fibers neighboring the lateral intercondylar ridge in the region of the direct insertion or the posterior, crescent-shaped fibers in the region of the indirect insertion, followed by the remainder of the ACL. The kinematics of the ACL-intact knee was replayed, and the reduction in force due to each sectioned portion of insertion fibers was measured. Isometry was assessed at anteromedial, center, and posterolateral locations within the high and low regions of the femoral footprint. Results: With an anterior tibial force at 30° of flexion, the high fibers carried 83.9% of the total anterior ACL load compared with 16.1% in the low fibers (P < .001). The high fibers also carried more anterior force than the low fibers at 90° of flexion (95.2% vs 4.8%; P < .001). Under combined torques at 15° of flexion, the high fibers carried 84.2% of the anterior ACL force compared with 15.8% in the low fibers (P < .001). Virtual ACL fibers placed at the anteromedial portion of the high region of the femoral footprint were the most isometric, with a maximum length change of 3.9 ± 1.5 mm. Conclusion: ACL fibers located high within the femoral footprint bear more force during stability testing and are more isometric during flexion than low fibers. Clinical Relevance: It may be advantageous to create a “higher” femoral tunnel during ACL reconstruction at the lateral intercondylar ridge.Keywords
This publication has 36 references indexed in Scilit:
- ACL Graft Position Affects in Situ Graft Force Following ACL ReconstructionJournal of Bone and Joint Surgery, 2015
- Evaluation of a simulated pivot shift test: a biomechanical studyKnee Surgery, Sports Traumatology, Arthroscopy, 2011
- Comparison of Anterior Cruciate Ligament Tunnel Position and Graft Obliquity With Transtibial and Anteromedial Portal Femoral Tunnel Reaming Techniques Using High‐Resolution Magnetic Resonance ImagingArthroscopy, 2011
- Lateral compartment translation predicts the grade of pivot shift: a cadaveric and clinical analysisKnee Surgery, Sports Traumatology, Arthroscopy, 2010
- Anatomy of Normal Human Anterior Cruciate Ligament Attachments Evaluated by Divided Small BundlesThe American Journal of Sports Medicine, 2009
- Morphology of the Femoral Intercondylar NotchJournal of Bone and Joint Surgery, 2007
- Distribution of in situ forces in the anterior cruciate ligament in response to rotatory loadsJournal of Orthopaedic Research, 2004
- Quantitative Analysis of Human Cruciate Ligament InsertionsArthroscopy, 1999
- Contribution of the passive properties of the rotator cuff to glenohumeral stability during anterior-posterior loadingJournal of Shoulder and Elbow Surgery, 1999
- The Use of a Universal Force-Moment Sensor to Determine In-Situ Forces in Ligaments: A New MethodologyJournal of Biomechanical Engineering, 1995