Corrosion Behavior of SUS 329J1 Stainless Steel in Formic Acid Solution
Authors:
- I. SekineISI. Sekine
- 1 March 1988
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 44 (3) , 136-142
Abstract
The corrosion behavior of SUS 329J1 stainless steel in formic acid solution was investigated by corrosion weight loss, polarization curves, and natural electrode potential (NEP) variation with time. The surfaces of specimens after corrosion weight loss tests were analyzed by electron spectroscopy for chemical analysis (ESCA). The corrosion weight loss of the steel at room temperature was very small, indicating that the steel had good corrosion resistance. At the boiling point, the corrosion of the steels was severe, with the maximum corrosion rate in 80% formic acid solution. From the analysis of the steel surface by ESCA, it was considered that the corrosion of the steel in 20% formic acid solution was inhibited by Cr-oxide (Cr2O3) as a protective film, and in 80% formic acid, the corrosion of the steel progressed because the passive film was not sufficiently stabilized by oxide of Cr or Mo. In nonaqueous formic acid solution (containing 1000 to 3000 ppm of water), the corrosion rate was presumed to decrease because the oxide of Mo and Cu were formed.Keywords
This publication has 8 references indexed in Scilit:
- Surface Composition of Stainless Steels during Anodic Dissolution and Passivation Studied by ESCAJournal of the Electrochemical Society, 1985
- Comparison of the Corrosion Behavior of Pure Fe, Ni, Cr, and Type 304 Stainless Steel in Formic Acid SolutionCorrosion, 1984
- The corrosion behaviour of SS 41 steel in formic and acetic acidsCorrosion Science, 1984
- The corrosion behaviour and hydrogen evolution reaction of Fe in non-aqueous formic acidCorrosion Science, 1982
- An X-ray photo-electron spectroscopic study on the role of molybdenum in increasing the corrosion resistance of ferritic stainless steels in HC1Corrosion Science, 1979
- Auger Electron Spectroscopic and Electrochemical Analysis of the Effect of Alloying Elements on the Passivation Behavior of Stainless SteelsCorrosion, 1978
- The role of molybdenum additions to austenitic stainless steels in the inhibition of pitting in acid chloride solutionsCorrosion Science, 1977
- Austenitic-Ferritic Stainless Steels with High Cr-Low Ni ContentJournal of the Japan Institute of Metals and Materials, 1968