A combined CFD and FE method, which could be applied to a wide range of internal air system rotor-stator cavities and which overcomes the disadvantages of many non-coupled approaches, is presented. It is used to predict windage and heat transfer in the HP compressor rear cone outer cavity of a service aeroengine. From the CFD it is shown that rotor wall torque, and hence windage, decreases as cavity throughflow increases, and that the data from several engine cavities can be reduced to a single characteristic of windage versus mass flow. Stator wall torque is also presented. A comparison with engine thermocouple data shows that further development of the modelling is required before engine testing could be replaced.