Experimental Study of Impulse Resuspension with Laser Doppler Vibrometry
Open Access
- 5 July 2012
- journal article
- research article
- Published by Taylor & Francis in Aerosol Science and Technology
- Vol. 46 (12) , 1303-1312
Abstract
Particle resuspension due to mechanical impulse was studied for spherical polymethylmethacrylate (pmma) particles ranging from 1.7 to 14.4 μm in diameter on titanium dioxide (TiO2) and silicon dioxide (SiO2) wafers. Dry powders were dispersed, electrostatically neutralized, and allowed to deposit under the influence of gravity. Contaminated surfaces were then mechanically excited with a 5 MHz piezoelectric transducer where surface accelerations (∼106 m/s2) and resuspension ratios were quantified with laser Doppler vibrometry (LDV) and digital microscopy, respectively. For TiO2, experiments were performed over a broad range of relative humidity (25 to 95%) to assess the effects of capillary condensation. Resuspension was a monotonically decreasing function of relative humidity. Existing theories were used to separate data into two adhesion regimes based on capillary bridge formation: van der Waals (vdW) and capillary dominated adhesion. For relative humidity above 60%, resuspension forces were nondimensionalized by the theoretical capillary force. Resuspension data for all particle sizes and relative humidity were described by a single sigmoid function dependent on the dimensionless resuspension force. Below 60% relative humidity, resuspension forces were nondimensionalized by the vdW force calculated with Johnson–Kendall–Roberts adhesion theory. The experimental work of adhesion (pmma-TiO2) was optimized such that the dimensionless resuspension curves, for capillary and vdW forces, had equivalent dimensionless resuspension forces at 50% resuspension. The calculated value, 0.047 J/m2, was within the range of values expected from other published works. Resuspension was not observed for particles on SiO2 substrates. This result was attributed to electrostatic surface charge patches where particle charge and surface resistivities were measured to analyze the relative influence of electrostatic adhesion forces. Copyright 2012 American Association for Aerosol ResearchKeywords
This publication has 32 references indexed in Scilit:
- Impact of Airflow Characteristics on Particle Resuspension from Indoor SurfacesAerosol Science and Technology, 2009
- Normal capillary forcesAdvances in Colloid and Interface Science, 2009
- Measurements of Air Jet Removal Efficiencies of Spherical Particles from Cloth and Planar SurfacesAerosol Science and Technology, 2008
- Determination of the adhesion force between particles and a flat surface, using the centrifuge techniquePowder Technology, 2007
- Capillary forces between surfaces with nanoscale roughnessAdvances in Colloid and Interface Science, 2002
- Small particle adhesion: measurement and controlColloids and Surfaces A: Physicochemical and Engineering Aspects, 2000
- Particle Charge Distribution Measurement for Commonly Generated Laboratory AerosolsAerosol Science and Technology, 1998
- Attractive Forces Between Micron-Sized Particles: A Patch Charge ModelThe Journal of Adhesion, 1995
- Toner AdhesionThe Journal of Adhesion, 1995
- Charge transfer in metal/polymer contactsJournal of Physics D: Applied Physics, 1987