The Effect of Martensite‐Austenite Constituent Characteristics on the Mechanical Behavior of Quenched‐Partitioned Steel at Room Temperature
- 9 October 2018
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 90 (3)
Abstract
The present study deals with the effect of constituent phase (austenite and martensite) characteristics on the microstructure and mechanical properties of an advanced high strength steel obtained through the quenching and partitioning (Q&P) process. The thermomechanical processing route is purposefully employed to modify the microstructures, to produce better mechanical properties. The final microstructures include first and second (fresh) martensite and retained austenite with film or blocky morphology in a wide range of size. The martensite laths mainly contribute in increasing the strength, and the retained austenite positively affects the ductility. Presence of a high fraction of high angle grain boundaries in the martensite laths indicate that the prior austenite grains are fully recrystallized in the thermomechanical process preceding the Q&P treatment. Although a lower carbon content is observed in the initial martensite of the specimen that is deformed during annealing treatment before the Q&P process, nevertheless, a higher work hardenability is found, because the lower carbon content is compensated by increasing the volume fraction of retained austenite and decreasing the martensite islands average sizes. The latter also the great film‐like retained austenite fraction besides the low amount of fresh martensite is found to improve the mechanical behavior significantly.Keywords
This publication has 34 references indexed in Scilit:
- Deformation-induced austenite grain rotation and transformation in TRIP-assisted steelActa Materialia, 2012
- High-energy X-ray diffraction study on the temperature-dependent mechanical stability of retained austenite in low-alloyed TRIP steelsActa Materialia, 2012
- Deformation and fracture mechanisms in fine- and ultrafine-grained ferrite/martensite dual-phase steels and the effect of agingActa Materialia, 2011
- Characterization of microstructure obtained by quenching and partitioning process in low alloy martensitic steelMaterials Science and Engineering: A, 2010
- Comparison of the Dislocation Density in Martensitic Steels Evaluated by Some X-ray Diffraction MethodsISIJ International, 2010
- In situ neutron diffraction investigation of the collaborative deformation–transformation mechanism in TRIP-assisted steels at room and elevated temperaturesActa Materialia, 2008
- The structure of nitrogen-supersaturated ferrite produced by ball millingPhilosophical Magazine, 2008
- Characterization of individual retained austenite grains and their stability in low-alloyed TRIP steelsActa Materialia, 2007
- Carbon partitioning into austenite after martensite transformationActa Materialia, 2003
- Austenite flow stress behaviour during continuous cooling through the metastable austenite regionActa Metallurgica et Materialia, 1995