Enhanced and Reusable Poly(hydroxy urethane)-Based Low Temperature Hot-Melt Adhesives
Open Access
- 10 January 2022
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Polymers Au
- Vol. 2 (3) , 194-207
Abstract
Poly(hydroxy urethane)s (PHUs) based on 5-membered cyclic carbonates have emerged as sustainable alternatives to conventional isocyanate-based polyurethanes. However, while from the point of view of sustainability they represent an improvement, their properties are still not competitive with conventional polyurethanes. In this work, the potential of PHUs as reversible hot-melt adhesives is discussed. We found that with a judicious choice of reagents (i.e., the dicyclic carbonate and diamine), the detrimental hydrogen bonding between the soft segment of the chains and the pendant hydroxyl groups was partially avoided, thus imparting PHUs with hot-melt adhesion properties (i.e., adhesion at elevated temperatures and cohesiveness at a temperature lower than Tg/Tm). The importance of a balanced hard to soft segment ratio, along with the relevance of the chain extender in the final properties, is highlighted. Addition of aliphatic diamines (HMDA, 1,12-DAD) resulted in rubbery materials, while the employment of cycloaliphatic (CBMA) or aromatic ones (MXDA, PXDA) led to materials with hot-melt adhesive properties. The thermoreversibility of all compositions was assessed by rebonding specimens after lap-shear tests. Lap-shear strength values that were comparable to the virgin adhesives were observed. The breaking and reformation of hydrogen bonding interactions was demonstrated by FTIR measurements at different temperatures, as well as by rheological frequency sweep experiments. In order to mitigate the negative impact of the low molar mass PHUs and to enhance the service temperature of the adhesives, a hybrid PHU was prepared by adding a small amount of an epoxy resin, which acts as a cross-linker. These hybrid PHUs maintain the thermoreversibility displayed by thermoplastic PHUs while providing better adhesion at elevated temperatures. We believe that this work provides some important insights into the design of PHU-based hot-melt adhesives.Keywords
Funding Information
- H2020 Marie Sklodowska-Curie Actions (955700)
This publication has 43 references indexed in Scilit:
- Current Research and Development Status and Prospect of Hot-Melt Adhesives: A ReviewIndustrial & Engineering Chemistry Research, 2008
- Skin Exposure to Isocyanates: Reasons for ConcernEnvironmental Health Perspectives, 2007
- Synthesis of silanized polyether urethane hybrid systems. Study of the curing process through hydrogen bonding interactionsEuropean Polymer Journal, 2006
- Hot-Melt AdhesivesMRS Bulletin, 2003
- Infrared spectroscopic studies of the urethane/ether inter-associationVibrational Spectroscopy, 2001
- Infrared spectroscopic studies of the self-association of ethyl urethaneVibrational Spectroscopy, 2000
- Phenyl isocyanate is a potent chemical sensitizerToxicology Letters, 1996
- Development of environmentally friendly warm-melt adhesives for the packaging industryInternational Journal of Adhesion and Adhesives, 1996
- The Preparation of Polymeric and Cyclic Urethans and Ureas from Ethylene Carbonate and AminesJournal of the American Chemical Society, 1957
- Phosgene Derivatives. The Preparation of Isocyanates, Carbamyl Chlorides and Cyanuric Acid1Journal of the American Chemical Society, 1950