All-Digital Outphasing Modulator for a Software-Defined Transmitter
Authors:
- 24 March 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 44 (4) , 1260-1271
Abstract
An all-digital outphasing modulator to be used in a software-defined radio (SDR) transmitter is presented. A digitally-controlled oscillator (DCO) followed by two digital phase rotators (DPR) are the main building blocks. The DCO and DPRs are enclosed, respectively, by a phase-locked loop and two delay-locked loop. All functions, including filtering and calibration are performed in a digital signal processor (DSP). The chip was fabricated in a 90 nm CMOS process and tested for GSM and WCDMA. The total active area of the chip is 3 mm2 . Semi-analog blocks (DCO core, DPR core and their buffers) and digital processor consume 30 mA and 25 mA, respectively. Current consumption of the phase-to-digital converter is 70 mA, which can be reduced to 30% by gating off the circuit during idle times.Keywords
This publication has 21 references indexed in Scilit:
- A 9 b, 1.25 ps Resolution Coarse–Fine Time-to-Digital Converter in 90 nm CMOS that Amplifies a Time ResidueIEEE Journal of Solid-State Circuits, 2008
- A fully digital architecture for wideband wireless transmitters2008
- Behavioral models of frequency pulling in oscillators2007
- A 4-GHz phase shifter MMIC in 0.18-/spl mu/m CMOSIEEE Microwave and Wireless Components Letters, 2005
- A compact triple-band low-jitter digital LC PLL with programmable coil in 130-nm CMOSIEEE Journal of Solid-State Circuits, 2005
- The combined analogue locked loop universal modulator (CALLUM)2003
- Physical processes of phase noise in differential LC oscillators2002
- A filtering technique to lower LC oscillator phase noiseIEEE Journal of Solid-State Circuits, 2001
- A new PLL frequency synthesizer with high switching speedIEEE Transactions on Vehicular Technology, 1992
- High Power Outphasing ModulationProceedings of the IRE, 1935