Study on mechanical properties of powder impregnated glass fiber reinforced poly(phenylene sulphide) by injection molding at various temperatures
Authors:
- 7 October 2009
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 115 (4) , 2019-2027
Abstract
The prepreg of continuous glass fiber reinforced poly(phenylene sulphide) (PPS) was prepared using the powder impregnation technique and cut into the pellets, in which the length of glass fibers was the same as the pellets. After injection molding, the mechanical properties were tested and the effects of the pellet length, fiber content, and thermal treatment on the mechanical properties at different temperatures were studied. It is found that the tensile strength and flexural strength of 6‐mm pellet sample are slightly higher than that of 3‐ and 12‐mm pellet samples. The tensile strength, flexural strength, and modulus decrease significantly with increasing the temperature. The notched Izod impact strength at 85ºC is higher than both at 25ºC and 205ºC. At 205ºC, the glass fiber reinforced PPS composites can still keep better mechanical properties. When the fiber content ranges from 0 to 50%, the mechanical properties increase with increasing the fiber contents at different temperatures, except the notched Izod impact strength do not further increase at 145 and 205ºC with raising the fiber content from 40 to 50%. Thermal treatment could improve the mechanical properties of the composites at higher serving temperature. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010Keywords
This publication has 16 references indexed in Scilit:
- Nonisothermal crystallization of polyamide 66/poly(phenylene sulfide) blendsJournal of Applied Polymer Science, 2007
- Mechanical and tribological properties of PA66/PPS blend. III. Reinforced with GFJournal of Applied Polymer Science, 2006
- Impact Strength and Crystallization Behavior of Nano‐SiOx/Poly(phenylene sulfide) (PPS) Composites with Heat‐Treated PPSMacromolecular Materials and Engineering, 2003
- Effect of nylon66 addition on the mechanical properties and fracture morphology of poly(phenylene sulfide)/glass fiber compositesPolymer Composites, 2003
- Mechanical properties and fracture morphologies of poly(phenylene sulfide)/nylon66 blends—effect of nylon66 content and testing temperatureJournal of Materials Science, 2000
- Effect of temperatures on the mechanical and morphological properties of polyphenylene sulfide compositesPolymer Bulletin, 1996
- Performance improvement of glass fiber-poly(phenylene sulfide) compositeJournal of Applied Polymer Science, 1996
- Fracture mechanism in short fibre reinforced thermoplastic resin compositesJournal of Materials Science, 1993
- Crystallization behavior of polyphenylene sulfide (PPS) and PPS/carbon fiber composites: Effect of curePolymer Bulletin, 1993
- Crystallization kinetics of poly(phenylene sulfide) (PPS) and PPS/carbon fiber compositesPolymer Engineering & Science, 1991