Influence of process-induced microstructure on hardness of two Al–Si alloys
Authors:
- Shadan TabibianSTShadan Tabibian
- Eric CharkalukECEric Charkaluk
- Andrei ConstantinescuACAndrei Constantinescu
- Gildas GuillemotGGGildas Guillemot
- Fabien SzmytkaFSFabien Szmytka
- 1 October 2015
- journal article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 646, 190-200
Abstract
No abstract availableKeywords
Funding Information
- PSA Peugeot-Citroën
- French Minister of Science
This publication has 21 references indexed in Scilit:
- Influence of constituents on the ductile fracture of Al–Cu–Mg alloys: Modulated by the aging treatmentMaterials Science and Engineering: A, 2009
- Nanoindentation and mechanical properties of solids in submicrovolumes, thin near-surface layers, and films: A ReviewPhysics of the Solid State, 2008
- Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodologyJournal of Materials Research, 2004
- The concept of net shape for castingsMaterials & Design (1980-2015), 2000
- Microstructure Design and Heat Treatment Selection for Casting Alloys Using the Quality IndexJournal of Materials Engineering and Performance, 2000
- The Dynamics of Frequency-Specific, Depth-Sensing Indentation TestingMRS Proceedings, 1998
- Effect of processing on the microstructural variation and heat-treatment response of a hypercutectic AlSi alloyJournal of Materials Processing Technology, 1995
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- Thermomechanical fatigue, oxidation, and creep: Part i. Damage mechanismsMetallurgical Transactions A, 1989
- Tip Surface Interactions in STM and AFMPhysica Scripta, 1987