Preparation and Characterization of New and Low-Cost Ceramic Flat Membranes Based on Zeolite-Clay for the Removal of Indigo Blue Dye Molecules
Open Access
Abstract
Composite flat membranes were prepared using a dry uniaxial pressing process. The effect of the sintering temperature (850–950 °C) and smectite proportion (10–50 wt.%) on membrane properties, such as microstructure, mechanical strength, water permeability, and treatment performances, was explored. It was observed that increasing the sintering temperature and adding higher amounts of smectite increased the mechanical strength and shrinkage. Therefore, 850 °C was chosen as the optimum sintering temperature because the composite membranes had a very low shrinkage that did not exceed 5% with high mechanical strength, above 23 MPa. The study of smectite addition (10–50 wt.%) showed that the pore size and water permeability were significantly reduced from 0.98 to 0.75 µm and from 623 to 371 L·h−1·m−2·bar−1, respectively. Furthermore, the application of the used membranes in the treatment of indigo blue (IB) solutions exhibited an almost total turbidity removal. While the removal of color and COD decreased from 95% to 76%, respectively, they decreased from 95% to 52% when the amount of smectite increased. To verify the treated water’s low toxicity, a germination test was performed. It has been shown that the total germination of linseed grains irrigated by MS10-Z90 membrane permeate was identical to that irrigated with distilled water. Finally, based on its promising properties, its excellent separation efficiency, and its low energy consumption, the MS10-Z90 (10 wt.% smectite and 90 wt.% zeolite) sintered at 850 °C could be recommended for the treatment of colored industrial wastewater.Keywords
Funding Information
- European Union
This publication has 38 references indexed in Scilit:
- Effect of carbonates composition on the permeation characteristics of low-cost ceramic membrane supportsJournal of Industrial and Engineering Chemistry, 2016
- Elaboration and characterization of a new flat ceramic MF membrane made from natural Moroccan bentonite. Application to treatment of industrial wastewaterApplied Clay Science, 2016
- Elaboration and characterization of flat membrane supports from Moroccan clays. Application for the treatment of wastewaterDesalination and Water Treatment, 2016
- Comparison of extruded and pressed low cost ceramic supports for microfiltration membranesJournal of the European Ceramic Society, 2015
- Elaboration of novel tubular ceramic membrane from inexpensive raw materials by extrusion method and its performance in microfiltration of synthetic oily wastewater treatmentJournal of Membrane Science, 2015
- Preparation and characterization of low cost ceramic membranes for mosambi juice clarificationDesalination, 2013
- Elaboration of new tubular ceramic membrane from local Moroccan Perlite for microfiltration process. Application to treatment of industrial wastewatersCeramics International, 2012
- Elaboration and characterisation of apatite based mineral supports for microfiltration and ultrafiltration membranesCeramics International, 2007
- Fungal decolorization of dye wastewaters: a reviewBioresource Technology, 2001
- Characterization of fouling kinetics in ultrafiltration systems by resistances in series modelDesalination, 2000