Finite element analysis of calibration factors for the modified incremental strain method
Authors:
- 1 January 2003
- journal article
- research article
- Published by SAGE Publications in The Journal of Strain Analysis for Engineering Design
- Vol. 38 (1) , 45-51
Abstract
To modify the incremental strain method used to evaluate non-uniform residual stress, a finite element analysis (FEA) of the reference model used to describe a hole-drilling test was conducted. The calibration factors for the x and y directions were obtained from the analysis and then their differences were compared under various loading conditions. A hole-drilling test using a steel plate as the reference specimen was introduced, and under the pure bending load, strain relaxation was measured at each hole-drilling step to determine the calibration factors. Although the calibration factors in the x and y directions varied with the boundary conditions used in the FEA, their differences were reduced to zero for all depths when the prescribed loads as the boundary conditions in the x and y directions became the same. In addition, it was analytically and experimentally confirmed that the calibration factors did not vary with the direction. Accordingly, by making the calibration factors equal in the x and y directions in the modified equation for the incremental strain method, no singularity is produced in the stress calculations.Keywords
This publication has 11 references indexed in Scilit:
- Experimental measurement and finite element simulation of the interaction between residual stresses and mechanical loadingInternational Journal of Fatigue, 2001
- Surface prestressing to improve fatigue strength of components by laser shot peeningOptics and Lasers in Engineering, 2000
- Experimental and numerical residual stress analysis of layer coated compositesMaterials Science and Engineering: A, 2000
- Finite-element solutions for mechanical drilling methods: A new integral formalismJournal of Computational and Applied Mathematics, 1995
- The development of new titanium arc-sprayed artificial jointsMaterials Science and Engineering: C, 1995
- EFFECT OF SHOT PEENING ON RESIDUAL STRESS AND FATIGUE LIFE OF A SPRING STEELFatigue & Fracture of Engineering Materials & Structures, 1995
- Measurement of Non-Uniform Residual Stresses Using the Hole-Drilling Method. Part II—Practical Application of the Integral MethodJournal of Engineering Materials and Technology, 1988
- Measurement of Non-Uniform Residual Stresses Using the Hole-Drilling Method. Part I—Stress Calculation ProceduresJournal of Engineering Materials and Technology, 1988
- Application of Finite Element Calculations to Residual Stress MeasurementsJournal of Engineering Materials and Technology, 1981
- Accurate measurement of residual stress on any steel using the centre hole methodStrain, 1976