9.7 a self-calibrated 10mb/s phase modulator with -37.4db evm based on a 10.1-to-12.4ghz, -246.6db-fom, fractional-n subsampling pll
Authors:
- 1 January 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 176-177
Abstract
The two-point injection scheme has proven to be an effective technique for overcoming the problem of PLL bandwidth limitations during wideband polar phase modulation [1]. The quality of the phase-modulated signal, typically expressed in terms of error-vector magnitude (EVM), still remains limited by the PLL phase-noise, gain mismatch between the two injection paths and linearity of the digital-to-modulated phase conversion. We present a phase modulator that makes use of an analog, fractional-N, digital-to-time-converter (DTC)-based subsampling PLL that achieves -37.4dB EVM around a 10.24GHz fractional carrier during 10Mb/s GMSK modulation. The subsampling PLL architecture uses no power-consuming divider and allows wide PLL bandwidth (because of its high phase-error detection gain) for optimal VCO noise suppression. The VCO has a secondary, digitally controlled capacitor bank (modulating DAC) used during two-point modulation. The gain errors and nonlinearities in the digital-to-modulated phase conversion are automatically background-calibrated in both injection points: in the phase-error detection path (where nonlinearity is dominated by the DTC INL) and in the VCO modulating capacitor bank (where nonlinearity is dominated by capacitor mismatch and nonlinear capacitance-to-frequency conversion).Keywords
This publication has 4 references indexed in Scilit:
- A 9.2–12.7 GHz Wideband Fractional-N Subsampling PLL in 28 nm CMOS With 280 fs RMS JitterIEEE Journal of Solid-State Circuits, 2015
- An Adaptive Pre-Distortion Technique to Mitigate the DTC Nonlinearity in Digital PLLsIEEE Journal of Solid-State Circuits, 2014
- A 20 Mb/s Phase Modulator Based on a 3.6 GHz Digital PLL With −36 dB EVM at 5 mW PowerIEEE Journal of Solid-State Circuits, 2012
- A Low Noise Sub-Sampling PLL in Which Divider Noise is Eliminated and PD/CP Noise is Not Multiplied by $N ^{2}$IEEE Journal of Solid-State Circuits, 2009