Hot Deformation Behavior of AA6061-T6 Aluminum Alloy: Flow Stress, Constitutive Modeling, and Microstructural Evolution
Preprint
- 3 July 2026
- preprint
- Published by MDPI AG in Preprints.org
Abstract
AA6061-T6 undergoes work hardening, dynamic recovery, and progressive flow softening during hot torsion, yet a systematic single-campaign dataset with quantified experimental uncertainty is absent from the literature. Gleeble hot torsion tests were conducted at eleven conditions from 250 to 450 °C and 0.91 to 9.07 s⁻¹. One-step Levenberg–Marquardt nonlinear regression simultaneously determined all four Garofalo–Arrhenius constants: Q = 151.1 kJ mol⁻¹ (consistent with Al lattice self-diffusion), n = 1.371, A = 3.51 × 10¹⁰ s⁻¹, and α = 0.045 MPa⁻¹. Training AARE = 15.5% (R = 0.908); leave-one-out cross-validation gives AARE = 23.0%, bounding the predictive uncertainty. The Prasad instability map identifies 400–450 °C at 0.91–2.72 s⁻¹ as the optimal hot-forming window; instability predicted at 350 °C is confirmed by macroscopic fracture in all specimens tested there. Optical microscopy in specimen T1 (ε_(eq) = 3.69) shows elongated subgrains at the gauge center and fine-grained zones near the fracture surface consistent with localized geometric dynamic recrystallization. Dynamic recovery is confirmed as the dominant restoration mechanism by the activation energy, smooth post-peak softening, and subgrain wall morphology. Adiabatic heating and a 24% inter-specimen repeatability scatter are quantified and propagated into the constitutive model uncertainty bounds. Because the training-to-cross-validation error gap (15.5% versus 23.0% AARE) reflects the limited three-level strain-rate matrix, the calibrated equation is recommended for interpolation within the tested window of 300 to 450 °C and 0.91 to 9.07 s⁻¹ and for forming-window identification, not for extrapolation beyond this domain without additional validation data.Keywords
All Related Versions
This publication has 15 references indexed in Scilit:
- Mechanical and Wear Properties of Graphite Reinforced Aluminum Metal Matrix Composites Processed by Ultrasonic-Stir-Squeeze CastingJournal of Materials Engineering and Performance, 2023
- Experimental investigation on nano refrigeration using TiO2 CuO and Al2O3 as refrigerantsMaterials Today: Proceedings, 2023
- Cyclic plastic zone-based notch analysis and damage evolution model for fatigue life prediction of metalsMaterials & Design, 2020
- Stress state-dependent mechanics of additively manufactured 304L stainless steel: Part 2 – Characterization and modeling of macroscopic plasticity behaviorMaterials Science and Engineering: A, 2019
- The Radial Temperature Gradient in the Gleeble® Hot-Torsion Test and Its Effect on the Interpretation of Plastic-Flow BehaviorMetallurgical and Materials Transactions A, 2017
- A review of dynamic recrystallization phenomena in metallic materialsMaterials & Design, 2016
- Investigation of work softening mechanisms and texture in a hot deformed 6061 aluminum alloy at high temperatureMaterials Science and Engineering: A, 2014
- Role of zirconia filler on friction and dry sliding wear behaviour of bismaleimide nanocompositesMaterials & Design (1980-2015), 2011
- Modeling of dynamic material behavior in hot deformation: Forging of Ti-6242Metallurgical Transactions A, 1984
- Plastic flow phenomenology of 304L stainless steelMetallurgical Transactions A, 1983