Challenges in electron cyclotron resonance plasma etching of LiNbO3 surface for fabrication of ridge optical waveguides
Authors:
- 1 July 1998
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 16 (4) , 2245-2251
Abstract
Ridge-shaped optical waveguides are promising structures to provide broadband characteristics for LiNbO3 (LN) based optoelectronic devices. In this regard, electron cyclotron resonance plasma etching with fluorocarbons have been commonly applied in the preparation of ridge waveguides, 3–5 μm in height, but certain fabrication problems need investigation and clarification. The etched LN surface was found to be covered with LiF leading to a weak adhesive strength for the overlayer, such as a SiO2 film, over the ridge waveguides. When CF4 etchant was used, a notch appeared along the foot of the ridge waveguides. The notch was a possible origin for the chipping of the waveguides. Such an undesirable notch was found to be prevented by the use of a CHF3 etchant. Here, these inevitable problems during the plasma etching of the LN were presented and discussed.Keywords
This publication has 6 references indexed in Scilit:
- Surface precipitates on single crystal LiNbO3 after dry-etching by CHF3 plasmaJournal of Materials Research, 1998
- Mach-Zehnder modulators with lithium niobate ridge waveguides fabricated by proton-exchange wet etch and nickel indiffusionIEEE Photonics Technology Letters, 1995
- A broadband Ti:LiNbO/sub 3/ optical modulator with a ridge structureJournal of Lightwave Technology, 1995
- Large differences in Ti thermal diffusion caused domain inversion between undoped and MgO-doped LiNbO3Applied Physics Letters, 1994
- Highly efficient 40-GHz bandwidth Ti:LiNbO/sub 3/ optical modulator employing ridge structureIEEE Photonics Technology Letters, 1993
- Ferroelectric domain inversion in Ti-diffused LiNbO3 optical waveguideJournal of Applied Physics, 1979