Predicting molding forces in SMC compression molding
Authors:
- 1 December 1990
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 30 (24) , 1568-1573
Abstract
A model relating molding force, compression speed, and part thickness, to material properties, part size, and processing conditions (mold and charge temperature) is necessary, to determine the ranges of closing speed feasible, when molding a predetermined part with a press of given capacity (tonnage). The faster we can close, in principle, the faster reacting systems we can run in a given press. A model has been developed to predict the force required for compression molding of SMC under non‐isothermal conditions. The model requires two material rheological parameters, namely, the material resistance to extension η and a friction coefficient λ. A method has been developed to measure these coefficients. Preheating the charge is an attractive way of decreasing the molding force required. Also higher molding temperatures would give lower friction and thus lower molding force.Keywords
This publication has 6 references indexed in Scilit:
- A Model for the Flow of a Chopped Fiber Reinforced Polymer Compound in Compression MoldingJournal of Applied Mechanics, 1986
- Kinematics of flow in sheet molding compoundsPolymer Composites, 1985
- Simulation of Compression Molding for Fiber-Reinforced Thermosetting PolymersJournal of Engineering for Industry, 1984
- The rheology and mold flow of polyester sheet molding compoundPolymer Composites, 1981
- Curing of compression molded sheet molding compoundPolymer Engineering & Science, 1981
- Predicting mold flow for unsaturated polyester resin sheet molding compoundsPolymer Composites, 1980