Wear prediction of die coatings in strip ironing by finite element simulation
Authors:
- 3 July 2016
- journal article
- research article
- Published by Taylor & Francis in Transactions of the IMF
- Vol. 94 (4) , 199-203
Abstract
This study has used a simple method to predict wear of die coatings used in the strip ironing of steel sheet based on Archard’s wear model by using finite element (FE) simulation. This method required the information regarding the quantity of worn material and thickness of die coatings. The die stresses obtained from the FE simulation were used to calculate the wear rate and wear depth per cycle. The die and sheet materials considered were D2 tool steel and S690QL, respectively. Two types of die coatings (CrN and TiN) and their known properties were studied. The studied sliding velocities were 0.1, 1.0 and 5.0 mm s−1. The contact pressures under investigation were 15, 150 and 1500 kPa. The results showed that TiN provided higher wear resistance due to its lower quantity of worn material (1.962 × 10−16 m3). The total wear depth per cycle increased with reducing quantity of worn material (increasing hardness value). Increase in sliding velocity led to increase in wear depth per cycle. The contact pressure (15–1500 kPa) did not significantly affect wear depth per cycle. To illustrate the acquired wear depth per cycle of all the coatings under different conditions, a predictive wear map was developed. In addition, the number of operating cycles based on the die coating thickness could be calculated. Based on the findings, the wear map could be used to help select appropriate die coatings and adjust process parameters in order to extend die service life.Keywords
This publication has 29 references indexed in Scilit:
- Performance of CrN radical nitrided tools on deep drawing of advanced high strength steelSurface and Coatings Technology, 2011
- Anti-adhesion performance of various nitride and DLC films against high strength steel in metal forming operationDiamond and Related Materials, 2010
- Sliding wear of nanocrystalline Ni–W: Structural evolution and the apparent breakdown of Archard scalingActa Materialia, 2010
- Tribological behaviour of W–Ti–N coatings in semi-industrial strip-drawing testsJournal of Materials Processing Technology, 2009
- Evaluation of stamping lubricants in forming advanced high strength steels (AHSS) using deep drawing and ironing testsJournal of Materials Processing Technology, 2009
- Tribology in Sheet Metal Forming with Regard to Challenges in Lightweight ConstructionAdvanced Materials Research, 2005
- Influence of surface roughness and coating type on the galling properties of coated forming tool steelSurface and Coatings Technology, 2004
- Development of a superlattice (Ti,Hf,Cr)N coating for cold metal forming applicationsSurface and Coatings Technology, 2004
- FEM simulation of surface smoothing in the ironing processJournal of Materials Processing Technology, 2001
- Mechanical properties of ion-plated TiN films on AISI D2 steelSurface and Coatings Technology, 1998