Simulating the Black Saturday 2009 smoke plume with an interactive composition‐climate model: Sensitivity to emissions amount, timing, and injection height
Open Access
- 9 March 2016
- journal article
- research article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Atmospheres
- Vol. 121 (8) , 4296-4316
Abstract
We simulated the high‐altitude smoke plume from the early February 2009 Black Saturday bushfires in southeastern Australia using the NASA Goddard Institute for Space Studies ModelE2. To the best of our knowledge, this is the first single‐plume analysis of biomass burning emissions injected directly into the upper troposphere/lower stratosphere (UTLS) using a full‐complexity composition‐climate model. We compared simulated carbon monoxide (CO) to a new Aura Tropospheric Emission Spectrometer/Microwave Limb Sounder joint CO retrieval, focusing on the plume's initial transport eastward, anticyclonic circulation to the north of New Zealand, westward transport in the lower stratospheric easterlies, and arrival over Africa at the end of February. Our goal was to determine the sensitivity of the simulated plume to prescribed injection height, emissions amount, and emissions timing from different sources for a full‐complexity model when compared to Aura. The most realistic plumes were obtained using injection heights in the UTLS, including one drawn from ground‐based radar data. A 6 h emissions pulse or emissions tied to independent estimates of hourly fire behavior produced a more realistic plume in the lower stratosphere compared to the same emissions amount being released evenly over 12 or 24 h. Simulated CO in the plume was highly sensitive to the differences between emissions amounts estimated from the Global Fire Emissions Database and from detailed, ground‐based estimates of fire growth. The emissions amount determined not only the CO concentration of the plume but also the proportion of the plume that entered the stratosphere. We speculate that this is due to either or both nonlinear CO loss with a weakened OH sink or plume self‐lofting driven by shortwave absorption of the coemitted aerosols.Keywords
Funding Information
- Natural Environment Research Council
This publication has 58 references indexed in Scilit:
- New fire diurnal cycle characterizations to improve fire radiative energy assessments made from MODIS observationsAtmospheric Chemistry and Physics, 2015
- Characterising Brazilian biomass burning emissions using WRF-Chem with MOSAIC sectional aerosolGeoscientific Model Development, 2015
- Anatomy of a catastrophic wildfire: The Black Saturday Kilmore East fire in Victoria, AustraliaForest Ecology and Management, 2012
- The meteorology of Black SaturdayQuarterly Journal of the Royal Meteorological Society, 2012
- A solar escalator: Observational evidence of the self‐lifting of smoke and aerosols by absorption of solar radiation in the February 2009 Australian Black Saturday plumeJournal of Geophysical Research: Atmospheres, 2012
- Lifting potential of solar‐heated aerosol layersGeophysical Research Letters, 2010
- An aerosol boomerang: Rapid around‐the‐world transport of smoke from the December 2006 Australian forest fires observed from spaceJournal of Geophysical Research: Atmospheres, 2009
- Large-eddy simulation of the plume generated by the fire at the Buncefield oil depot in December 2005Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2008
- Fast-J2: Accurate Simulation of Stratospheric Photolysis in Global Chemical ModelsJournal of Atmospheric Chemistry, 2002
- Emission of trace gases and aerosols from biomass burningGlobal Biogeochemical Cycles, 2001