Electron beam absorption in 3D-printed polymer samples with different infill densities
Open Access
- 1 October 2019
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1337 (1) , 012003
Abstract
In this work, we study the efficiency of electron absorption by the plastic samples produced using 3D printing with different infill densities. We investigate the influence of the print layer orientation relative to the electron beam axis on the radiation dose distribution. It is possible to produce plastic samples with different infill by fused deposition modelling. Ten polymer test samples with the infill density ranging from 10% to 100% are printed and studied experimentally using a 6 MeV electron beam of an MIB-6E betatron. GafChromic EBT3 films are used for the dose measurement. When the infill is above 70%, the difference of dose distribution uniformity cannot be distinguished for the two print layer orientations. Therefore, these samples can be used for electron beam formation.Keywords
This publication has 5 references indexed in Scilit:
- Investigation of the Therapeutic Electron Beams Formation Efficiency by Metal Collimators and Products Manufactured by Rapid Prototyping TechniquePhysics of Particles and Nuclei Letters, 2018
- Intraoperative radiotherapy in combined treatment of sinonasal malignant tumorsAIP Conference Proceedings, 2017
- TEN-YEAR OUTCOMES AFTER BREAST-CONSERVING SURGERY WITH INTRAOPERATIVE RADIOTHERAPY FOR BREAST CANCERSiberian journal of oncology, 2017
- Gafchromic EBT3 film dosimetry in electron beams — energy dependence and improved film read‐outJournal of Applied Clinical Medical Physics, 2016
- Intraoperative radiation therapy using mobile electron linear accelerators: Report of AAPM Radiation Therapy Committee Task Group No. 72Medical Physics, 2006