XRD Analysis of Cu-Al Interconnect Intermetallic Compound in an Annealed Micro-Chip
- 13 December 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 620, 166-172
Abstract
Cu-Al intermetallic compound (IMC) in Cu wire-Al bond pad interconnect interface is drawing attention of researches. However, due to thin IMC thickness, the characterizations of the IMC are limited to expensive and time consuming techniques. An evaluation is performed to use common X-Ray Diffraction (XRD) technique to identify the IMC in the Cu wired micro-chip samples in powder form. Existence of mixture of CuAl and CuAl2 was first confirmed by transmission electron microscope (TEM) and energy dispersive X-ray (EDX). In XRD analysis, peak correspond to CuAl phase is identified from measurement with slower scan configuration. The difficulty for IMC peak detection in diffractogram is due to low composition ratio of IMC relative to other materials available in the sample. KOH treatment for enhancing IMC peaks intensity does not work as expected as it etches the IMC as well.Keywords
This publication has 13 references indexed in Scilit:
- Behavior of aluminum oxide, intermetallics and voids in Cu–Al wire bondsActa Materialia, 2011
- Nickel–palladium bond pads for copper wire bondingMicroelectronics Reliability, 2011
- A brief review of selected aspects of the materials science of ball bondingMicroelectronics Reliability, 2010
- Growth of Intermetallic Compounds in Thermosonic Copper Wire Bonding on Aluminum MetallizationJournal of Electronic Materials, 2009
- Detailed investigation of ultrasonic Al–Cu wire-bonds: I. Intermetallic formation in the as-bonded stateJournal of Materials Science, 2008
- Growth behavior of Cu/Al intermetallic compounds and cracks in copper ball bonds during isothermal agingMicroelectronics Reliability, 2008
- Grains, deformation substructures, and slip bands observed in thermosonic copper ball bondingMaterials Characterization, 2003
- Photochemical Dry Stripping of Silicon Nitride FilmsJournal of the Electrochemical Society, 1995
- Optimization of copper wire bonding on Al-Cu metallizationIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part A, 1995
- The aluminium-copper systemInternational Materials Reviews, 1985