Hydrofluoric acid flow etching of low-loss subwavelength-diameter biconical fiber tapers
Authors:
- 8 October 2010
- journal article
- Published by Optica Publishing Group in Optics Express
- Vol. 18 (21) , 22593-22598
Abstract
An etch method based on surface tension driven flows of hydrofluoric acid microdroplets for the fabrication of low-loss, subwavelength-diameter biconical fiber tapers is presented. Tapers with losses less than 0.1 dB/mm are demonstrated, corresponding to an order of magnitude increase in the optical transmission over previous acid-etch techniques. The etch method produces adiabatic taper transitions with minimal surface corrugations. A biconical fiber taper fabricated using this method is used to demonstrate an erbium doped silica microsphere laser.Keywords
This publication has 17 references indexed in Scilit:
- Optical fibre nanowires and microwires: a reviewJournal of Optics, 2010
- Marangoni flow revisitedJournal of Colloid and Interface Science, 2009
- A review of fiber-optic biosensorsSensors and Actuators B: Chemical, 2007
- Subwavelength-diameter silica wires for low-loss optical wave guidingNature, 2003
- Fabrication of biconical tapered optical fibers using hydrofluoric acidMaterials Science and Engineering: B, 2003
- Phase-matched excitation of whispering-gallery-mode resonances by a fiber taperOptics Letters, 1997
- Surface activity of amphiphiles in hydrogen fluoride ? water solutionsColloid and Polymer Science, 1995
- Investigations of the surface conductivity of silicon dioxide and methods to reduce itSurface Science, 1987
- Reaction of High‐Silica Optical Fibers with Hydrofluoric AcidJournal of the American Ceramic Society, 1984
- Coupling of Modes on a Tapered Dielectric CylinderIEEE Transactions on Microwave Theory and Techniques, 1970