In Situ Observation of the Tensile Deformation and Fracture Behavior of Ti–5Al–5Mo–5V–1Cr–1Fe Alloy with Different Microstructures
Open Access
Abstract
The plastic deformation processes and fracture behavior of a Ti–5Al–5Mo–5V–1Cr–1Fe alloy with bimodal and lamellar microstructures were studied by room-temperature tensile tests with in situ scanning electron microscopy (SEM) observations. The results indicate that a bimodal microstructure has a lower strength but higher ductility than a lamellar microstructure. For the bimodal microstructure, parallel, deep slip bands (SBs) are first noticed in the primary α (αp) phase lying at an angle of about 45° to the direction of the applied tension, while they are first observed in the coarse lath α (αL) phase or its interface at grain boundaries (GBs) for the lamellar microstructure. The β matrix undergoes larger plastic deformation than the αL phase in the bimodal microstructure before fracture. Microcracks are prone to nucleate at the αp/β interface and interconnect, finally causing the fracture of the bimodal microstructure. The plastic deformation is mainly restricted to within the coarse αL phase at GBs, which promotes the formation of microcracks and the intergranular fracture of the lamellar microstructure.Keywords
Funding Information
- State Key Laboratory of Powder Metallurgy (10500-621022001)
This publication has 31 references indexed in Scilit:
- Processing-microstructure-yield strength correlation in a near β Ti alloy, Ti–5Al–5Mo–5V–3CrMaterials Science and Engineering: A, 2014
- Effect of microstructures on ballistic impact property of Ti–6Al–4V targetsMaterials Science and Engineering: A, 2014
- Microstructure and high cycle fatigue fracture surface of a Ti–5Al–5Mo–5V–1Cr–1Fe titanium alloyMaterials Science and Engineering: A, 2013
- Transgranular shearing introduced brittlement of Ti–5Al–5V–5Mo–3Cr alloy with full lamellar structure at room temperatureMaterials Science and Engineering: A, 2013
- Tensile and fracture toughness of high strength β Titanium alloy, Ti–10V–2Fe–3Al, as a function of rolling and solution treatment temperaturesMaterials & Design (1980-2015), 2013
- In-situ SEM observations of tensile deformation of the lamellar microstructure in TC21 titanium alloyMaterials Science and Engineering: A, 2013
- Tensile and fracture properties of Ti‐62A alloy plate with different microstructuresRare Metals, 2012
- Cyclic deformation response and micromechanisms of Ti alloy Ti–5Al–5V–5Mo–3Cr–0.5FeMaterials Science and Engineering: A, 2011
- Dynamic fracture toughness of TA15ELI alloy studied by instrumented impact testRare Metals, 2010
- Microstructure and Slip Character in Titanium AlloysDefence Science Journal, 1986