Basic laboratory experiments with an educational robotic arm
Authors:
- 1 June 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 510-515
Abstract
This work addresses design and construction issues of a laboratory robotic arm for educational purposes. First of all, the robotic arm performance analysis has been accomplished using Matlab / Simulink / SimMechanics. The obtained knowledge has been utilized to develop the suitable algorithms for analyzing the robotic arm kinematics. Once the SimMechanics model is successfully determined, a real-time xPC target system is used in order to connect the real laboratory robotic arm with the corresponding Matlab / Simulink block diagram. It is important to remark that the developed robotic arm is a convenient tool for learning robotics at any favorable technical university laboratory. On the other hand, the manipulator has six degrees of freedom. Three degrees of freedom correspond to the robotic arm and the rest belongs to the gripper. Moreover, the necessary electronic modules have been developed in order to allow a successful standard communication with the available l aboratory devices.Keywords
This publication has 8 references indexed in Scilit:
- Simulation of force control algorithms for serial robots2012
- Redundant inverse kinematics: Experimental comparative review and two enhancements2012
- Kinematic analysis of a dual-arm humanoid cooking robot2012
- Hardware-in-the-Loop approach to controller design and testing of motion control systems using xPC Target2012
- Hardware-in-the-Loop approach to the development and validation of precision induction motor servo drive using xPC Target2012
- Hexapod robot locomotion over typical obstacles2012
- Real-Time Control Prototyping in MATLAB/Simulink: Review of tools for research and education in mechatronics2011
- Forward and inverse kinematics model for robotic welding process using KR-16KS KUKA robot2011