Effect of Laser Parameters on Microstructure and Fracture Properties of Repaired Cracks with Micro/Nano Material Addition
Authors:
- 20 March 2020
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 142 (5) , 1-20
Abstract
Compact tension specimens with prefabricated cracks are repaired by laser with micro/nano materials added at the crack tip. Different combinations of laser parameters, i.e., laser power, laser spot diameter and heating time, were applied to investigate their effects on the microstructures and fracture properties of repaired specimens. J-integrals were calculated according to the digital image correlation (DIC) measurements, and microstructures were examined using scanning electron microscopy (SEM). When suitable laser parameters were used, homogeneous and compact equiaxed grains with no cracks, pores, and agglomeration are observed in the repaired layer, and the J-integral of repaired specimens is approximately 20% less than that of unrepaired specimen. The paper reveals relations among laser parameters, J-integrals, and microstructures, and provides a guideline for the selection of laser repair parameters.Keywords
Funding Information
- National Natural Science Foundation of China (51575076)
This publication has 20 references indexed in Scilit:
- A Numerical Study on the Keyhole Formation During Laser Powder Bed Fusion ProcessJournal of Manufacturing Science and Engineering, 2019
- Selective Laser Melting of Mechanically Alloyed Metastable Al5Fe2 PowdersJournal of Manufacturing Science and Engineering, 2019
- Direct laser cladding of the silicide dispersed titanium aluminide (Ti45Al5Nb0.5Si) compositesOptics & Laser Technology, 2018
- Wear and corrosion resistance of laser cladding AISI 304 stainless steel/Al2O3 composite coatingsSurface and Coatings Technology, 2014
- Crack Free Tungsten Carbide Reinforced Ni(Cr) Layers obtained by Laser CladdingPhysics Procedia, 2011
- Elucidation of high-power fibre laser welding phenomena of stainless steel and effect of factors on weld geometryJournal of Physics D: Applied Physics, 2007
- Welding with high power fiber lasers – A preliminary studyMaterials & Design (1980-2015), 2007
- Influence of cyclic temperature changes on the microstructure of AISI 4140 after laser surface hardeningActa Materialia, 2007
- Prediction of phase transformations during laser surface hardening of AISI 4140 including the effects of inhomogeneous austenite formationMaterials Science and Engineering: A, 2006
- Influence of heating rate, cooling rate and numbers of pulses on the microstructure of AISI 4140 after short-time-hardeningInternational Journal of Materials and Product Technology, 2005