A Shared Aperture X/Ku-Band 5-Group- 5-Element Series-Fed Center-Fed Antenna Array With Isolation Improvement for Airborne Synthetic Aperture Radar Applications
Open Access
- 14 August 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 86271-86284
Abstract
This research paper introduces a novel dual-band single-polarized (DBSP) high gain shared aperture antenna (SAA) with better isolation is proposed for the use in Airborne Synthetic Aperture Radars (AIR-SARs). The SAA operating in both X-band and Ku-band with center frequencies of 9.3GHz (ideal for soil moisture estimation in agricultural areas) and 13.265GHz (suitable for applications in snow-covered regions, cold areas, and disaster monitoring) with a frequency ratio of 1:1.426. The SAA consists of four groups of 5-element series-fed center-fed planar array square microstrip patches for the X-band and one group of 5-element series-fed center-fed planar array square microstrip patches for the Ku-band. The inter-element spacing between patches is set at 0.7λ to meet the ±25° scan range requirements. To validate the antenna design, a prototype is fabricated and tested for S-parameters, radiation characteristics, and gain measurements. The antenna with return loss of S11 < -10 dB has an impedance bandwidth (BW) (9.1919-9.4674 GHz) (276 MHz with 2.96% BW) in X-band and (13.054-13.513 GHz) (459 MHz with 3.46% BW) in Ku-band. More than 25 dB of isolation has been measured between S 21 =S 12 for case 3 and are >35dB isolation between in-band ports (P12/P23/P13) for case 4. Additionally, it achieves high gain values of 12.8 dBi for the X-band and 12 dBi for the Ku-band for case 3. The 2×2 planar array (5-elements in each group excited with coaxial probe feed) is connected with 8-way power divider (4-groups are feed with 4 power divider ports and other 4-ports are matched with 50Ω terminations) and achieved a gain of 19 dBi for the X-band and 12 dBi for the Ku-band for case 4. The combined gain is varied between 19dBi to 20dBi with 0° to 25° scan angle. The combined 2×2 planar x-band array Half-Power Beam width (HPBW) values are 16° in the E-plane and 12.6° in the H-plane for the X-band, while for the Ku-band, they are 22.7° in the E-plane and 78.4° in the H-plane. The antenna design shows a side-lobe level (SLL) of -16.2 dB at E-plane/φ=0° for the X-band and -14.1 dB at E-plane/φ=0° for the Ku-band. The size of the shared-aperture antenna is 160 mm × 160 mm × 1.6 mm. This paper presents the first reported SAA X/Ku-DBSP, which holds significant value for AIR-SAR applications. All the measured results were in line with simulated results and matched reasonably well.Keywords
This publication has 37 references indexed in Scilit:
- Low-Cost X/Ku/Ka-Band Dual-Polarized Array With Shared ApertureIEEE Transactions on Antennas and Propagation, 2017
- A SINGLE LAYER S/X-BAND SERIES-FED SHARED APERTURE ANTENNA FOR SAR APPLICATIONSProgress in Electromagnetics Research C, 2017
- High-Isolation X-Band Marine Radar Antenna DesignIEEE Transactions on Antennas and Propagation, 2014
- SHARED-APERTURE DUAL-BAND DUAL-POLARIZATION ARRAY USING SANDWICHED STACKED PATCHProgress in Electromagnetics Research C, 2014
- A tutorial on synthetic aperture radarIEEE Geoscience and Remote Sensing Magazine, 2013
- High resolution SAR change detection in Hong Kong2011
- Snow covered area retrieval using ENVISAT ASAR wideswath in mountainous areas2004
- Comparison of three series fed microstrip array geometries2002
- Slick detection in SAR images2002
- Synthetic aperture radar interferometryProceedings of the IEEE, 2000