Uncertainty Inverse Analysis of Positioning Accuracy for Error Sources Identification of Industrial Robots
- 1 November 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Reliability
- Vol. 72 (3) , 1123-1133
Abstract
Uncertainties widely exist in modeling parameters of industrial robots due to wear during service. These uncertainties are too small to be directly measured and may severely affect the positioning accuracy of end-effector through multi-stage propagation. An uncertainty inverse analysis method of positioning accuracy is proposed to identify uncertainty of typical structural parameters with the selected optimal position information. The Denavit–Hartenberg method is employed to establish the kinematic model. For the probability uncertainty of modeling parameters, the inverse analysis model, which reflects propagation mapping between uncertain variables and end-effector position response is obtained by first-order second-moment method. The partial-derivative information is used to improve calculation efficiency through removing low-contributing parameters. To further reduce measurement noise interference, orthogonal matching pursuit strategy is presented to search optimal sensor placement with the objectives of maximum coefficient modulus and minimum correlation, then pseudoinverse matrix method is employed to obtain the exact solution of identification equation. Finally, numerical simulation results for 6 degrees-of-freedom robots indicate that the proposed method with improved solution efficiency can accurately identify uncertainties of joint angles within the error 5% under large measurement errors.Keywords
Funding Information
- National Natural Science Foundation of China (51975199, 51805155)
- Changsha Municipal Natural Science Foundation (kq2014050)
This publication has 42 references indexed in Scilit:
- Service Robotics and Human Labor: A first technology assessment of substitution and cooperationRobotics and Autonomous Systems, 2017
- Determination of optimal samples for robot calibration based on error similarityChinese Journal of Aeronautics, 2015
- Optimal pose selection for calibration of planar anthropomorphic manipulatorsPrecision Engineering, 2015
- Analysis of the Kinematic Accuracy Reliability of a 3-DOF Parallel Robot ManipulatorInternational Journal of Advanced Robotic Systems, 2015
- A genetic algorithm approach to a neural-network-based inverse kinematics solution of robotic manipulators based on error minimizationInformation Sciences, 2013
- A Hybrid Reliability Approach Based on Probability and Interval for Uncertain StructuresJournal of Mechanical Design, 2012
- Uncertainty analysis and allocation of joint tolerances in robot manipulators based on interval analysisReliability Engineering & System Safety, 2007
- Probabilistic approach to manipulator kinematics and dynamicsReliability Engineering & System Safety, 2001
- Uncertainty analysis of planar and spatial robots with joint clearancesMechanism and Machine Theory, 2000
- Factorial Sampling Plans for Preliminary Computational ExperimentsTechnometrics, 1991