Numerical Analysis of Space Trusses With Flexible Member-End Joints
Author:
- 1 September 1993
- journal article
- research article
- Published by SAGE Publications in International Journal of Space Structures
- Vol. 8 (3) , 189-197
Abstract
The conventional procedure for the analysis of space trusses, lattice domes and similar structures, assumes that member-end joints behave as pure pins or, in some cases, as rigid joints. However, experimental studies have shown that these joints typically exhibit some level of flexural stiffness and are therefore flexible (semi-rigid). It was reported that the characteristics of the space truss jointing system play a major role in truss response (see Refs. 1,2,3). The results of experiments conducted on space trusses with rigid or flexible joints produced less brittle behaviour than that found for assemblies with nominally-pinned joints. A nonlinear beam-column element with end springs has been developed to model the actual rotational stiffness of truss member-node connections, and its stiffness expressions are presented in this paper. Incorporation of this element in the numerical analysis of space trusses has led to better predictions of behaviour and strength when compared to the commonly-used two-noded frictionless truss element. This new element was used successfully in the numerical analysis of two non-composite and one composite double-layer space truss, and the results are presented in this paper.Keywords
This publication has 5 references indexed in Scilit:
- Modification of Behavior of Double‐Layer Grids: OverviewJournal of Structural Engineering, 1989
- Ultimate Load Testing of Space TrussesJournal of the Structural Division, 1982
- ULTIMATE LOAD BEHAVIOUR OF A FULL SCALE SPACE TRUSS.Proceedings of the Institution of Civil Engineers, 1980
- Tangent Stiffness in Space FramesJournal of the Structural Division, 1973
- Nonlinear Behavior of Structural Plane FramesJournal of the Structural Division, 1963