Multi-layer kinematics and collision energy in a large-scale grinding mill-the largest semi-autogenous grinding mill in China
Authors:
Open Access
- 1 November 2016
- journal article
- research article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 8 (12)
Abstract
Using the largest semi-autogenous grinding mill in China as a model, collision energy was analyzed on the basis of the multi-layer kinematics of the steel balls. First, the kinematic equation of the steel balls was obtained by considering the multi-layer characteristics of the steel balls. Second, the collision energy of the inner-layer steel balls was addressed according to its kinematic characteristics. Finally, the total collision energy per unit time was obtained. Results show that the leaving angle decreases as the mill speed ratio increases and as the radius ratio increases, but the leaving velocity increases linearly. Moreover, a discontinuity point of the tangential collision velocity occurs at an angle factor β = 0, and the angle factor β is divided into two intervals: [−3, 0] and [0, 1.5]. The leaving angles corresponding to a tangential velocity equal to zero are calculated to be 1.185 and 0.7854 rad in the two intervals. In addition, the sum collision velocity increases when β is less than zero, but it decreases sharply above zero. The maximum total collision energy per unit time occurs at 84.2% of the mill speed corresponding to the optimal mill speed ratio.Keywords
This publication has 19 references indexed in Scilit:
- Experimental validation of 2D DEM code by digital image analysis in tumbling millsMinerals Engineering, 2012
- Optimisation of the secondary ball mill using an on-line ball and pulp load sensor – The SensomagMinerals Engineering, 2011
- Experimental observations of lifter parameters and mill operation on power draw and liner impact loadingMinerals Engineering, 2010
- Experimental analysis of wet mill load based on vibration signals of laboratory-scale ball mill shellMinerals Engineering, 2010
- Particle methods for modelling in mineral processingInternational Journal of Computational Fluid Dynamics, 2009
- DEM prediction of particle flows in grinding processesInternational Journal for Numerical Methods in Fluids, 2008
- An empirical power model derived from 3D particle tracking experimentsMinerals Engineering, 2006
- Recent advances in dem modelling of tumbling millsMinerals Engineering, 2001
- Impact energy spectra of tumbling millsPowder Technology, 2000
- Simulation of charge motion in ball mills. Part 2: numerical simulationsInternational Journal of Mineral Processing, 1994