Two-cavity MEMS variable capacitor for power harvesting
Open Access
- 27 April 2012
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 22 (6) , 065003
Abstract
Novel 2 × 2 mm2 MEMS capacitive plates with two cavities (two capacitors) have been designed, modeled and fabricated for power harvesting by utilizing residual mechanical vibration in the environment using the electrostatic mechanism. The device is unique in the use of an innovative two-cavity design and electroplated nickel as the main structural material. When the capacitance increases for one capacitor, it will decrease for the other. This allows us to use both up and down directions to generate energy. The two-cavity design has achieved higher average power than conventional single-cavity devices under a wide range of vibration frequencies and amplitudes based on the time-domain simulations using Matlab. The movable plate was designed to vibrate without deformation and with resonance frequencies of around 900 Hz and lower using COMSOL finite element tool. The prototype two-cavity MEMS variable capacitor has been successfully fabricated using surface micromachining. The initial testing to investigate the electrical dynamic behavior and power generation from the fabricated devices was also implemented.Keywords
This publication has 21 references indexed in Scilit:
- Piezoelectric MEMS Energy Harvester for Low-Frequency Vibrations With Wideband Operation Range and Steadily Increased Output PowerJournal of Microelectromechanical Systems, 2011
- Integrated power harvesting system including a MEMS generator and a power management circuitSensors and Actuators A: Physical, 2008
- Effect of ammoniating temperature on structural and morphologic properties of nanostructured GaNMicroelectronics Journal, 2008
- Vibrational energy scavenging with Si technology electromagnetic inertial microgeneratorsMicrosystem Technologies, 2007
- Energy harvesting vibration sources for microsystems applicationsMeasurement Science and Technology, 2006
- Modelling and performance evaluation of a MEMS dc/dc converterJournal of Micromechanics and Microengineering, 2006
- MEMS power generator with transverse mode thin film PZTSensors and Actuators A: Physical, 2005
- Modelling and analysis of a MEMS approach to dc voltage step-up conversionJournal of Micromechanics and Microengineering, 2004
- An electromagnetic, vibration-powered generator for intelligent sensor systemsSensors and Actuators A: Physical, 2004
- Development of an electromagnetic micro-generatorElectronics Letters, 1997