Optimal Fracture Spacing and Stimulation Design for Horizontal Wells in Unconventional Gas Reservoirs
Authors:
- 30 October 2011
- conference paper
- Published by Society of Petroleum Engineers (SPE)
Abstract
Hydraulic fracturing of horizontal wells is crucial for economic production of natural gas from unconventional reservoirs. For transverse fractures, existing approaches for making decisions on fracture spacing and length are based on sensitivity analysis using reservoir and/or fracture propagation simulators. The use of commercial simulators relies on assessment of various what-if scenarios, which are set up based on experience and data collected from completed wells in the same or similar reservoirs. Because of the large number of possible decision variables, the decision-making process is complex, potentially leading to non-optimal. A computer-aided tool that could facilitate the process would allow engineers to efficiently converge to solutions that are at or close to the optimum. The proposed approach relies on a novel efficient numerical optimization tool. The optimization objective function is Net Present Value (NPV) for horizontal wells drilled in the direction of the minimum horizontal stress, which allows multiple transverse fractures. Key decision variables are number of transverse fractures in a horizontal well; horizontal well length; proppant concentration; injection rate of fracturing fluid; injection time; fluid performance index and fluid consistency index. Key design constraints are fracture growth control, and geometric constraints. To set up the optimization, critical reservoir properties are assumed to be available from a variety of sources (e.g., seismic, prior production logs). The modified PKN model along with Carter's Equation for material balance is used for hydraulic fracturing propagation where fracture width, half length and net pressure are calculated. Productivity of multiple fractured horizontal wells is computed by using analytical equations. A robust optimization algorithm is used for finding the optimum parameters. The capability and robustness of the proposed approach is demonstrated for a tight gas reservoir for which horizontal well geometry and its fracturing treatment is designed based on numerical simulations. A commercial simulator served as virtual reservoir with properties calibrated based on SPE case studies. The simulation show optimization can significantly increase NPV over other available solutions. Sensitivity analysis is done on various decision variables to show their significance in decision making for well stimulation. Also, significance of choosing optimum number of operating years is discussed in order to avoid missing optimum recovery. It is shown how important it is to find the optimum number of years for a particular formation which can give the maximum profit. The proposed tool can provide a quantitative assessment of optimal horizontal well stimulations. It is envisioned to be used in an integrated decision support system that will help engineers to use a multitude of available data for development of unconventional gas resources.Keywords
This publication has 40 references indexed in Scilit:
- Pseudo‐Steady‐State Productivity Formula for a Partially Penetrating Vertical Well in a Box‐Shaped ReservoirMathematical Problems in Engineering, 2010
- The GLOBAL optimization method revisitedOptimization Letters, 2007
- Multicriteria Hydraulic Fracturing Optimization for Reservoir StimulationPetroleum Science and Technology, 2003
- Rock mechanics and stimulation aspects of horizontal wellsJournal of Petroleum Science and Engineering, 2000
- Using a three-dimensional concept in a two-dimensional model to predict accurate hydraulic fracture dimensionsJournal of Petroleum Science and Engineering, 1995
- Interpretation of Fracturing PressuresJournal of Petroleum Technology, 1981
- Unsteady-State Pressure Distributions Created by a Well With a Single Infinite-Conductivity Vertical FractureSociety of Petroleum Engineers Journal, 1974
- A Study of Inclined Hydraulic FracturesSociety of Petroleum Engineers Journal, 1973
- Propagation of a Vertical Hydraulic FractureSociety of Petroleum Engineers Journal, 1972
- Widths of Hydraulic FracturesJournal of Petroleum Technology, 1961