A novel gate assisted circuit to reduce switching loss and eliminate shoot-through in SiC half bridge configuration
Authors:
- 1 March 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3058-3064
Abstract
The trend towards SiC-based high power density converter requires to drive SiC MOSFET with high-speed switching. However, it tends to aggravate dv/dt effect due to the impact of parasitic parameters, resulting in shoot-through and high device stress in the half bridge configuration. In this work, a novel gate assisted circuit is proposed to eliminate shoot-through issue without compromise on switching speed. The mathematical model for the gate assisted circuit is developed. Then the switching test experiment is set up to validate its performance with commercial SiC half bridge module, which shows a high dv/dt up to 20 and 31 V/ns at turn-on and turn-off respectively and a 34% reduction of switching loss without any shoot-through issue.Keywords
This publication has 8 references indexed in Scilit:
- Gate driver optimization to mitigate shoot-through in high-speed switching SiC half bridge module2015
- A 1200-V, 60-A SiC MOSFET Multichip Phase-Leg Module for High-Temperature, High-Frequency ApplicationsIEEE Transactions on Power Electronics, 2014
- A study on self turn-on phenomenon in fast switching operation of high voltage power MOSFET2013
- Active Gate Driver for Crosstalk Suppression of SiC Devices in a Phase-Leg ConfigurationIEEE Transactions on Power Electronics, 2013
- Design of DC-side wiring structure for high-speed switching operation using SiC power devices2013
- A novel gate assist circuit for quick and stable driving of SiC-JFETs in a 3-phase inverter2012
- Power Conversion With SiC Devices at Extremely High Ambient TemperaturesIEEE Transactions on Power Electronics, 2007
- Low stray inductance bus bar design and construction for good EMC performance in power electronic circuitsIEEE Transactions on Power Electronics, 2002