A 1.2V 38nm 2.4Gb/s/pin 2Gb DDR4 SDRAM with bank group and ×4 half-page architecture
Authors:
- 1 February 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01936530,p. 40-41
Abstract
DDR4 SDRAM is expected to realize low power consumption and high bandwidth using a 1.2V nominal supply voltage and to be a cost-effective solution for various applications. In this paper, bank group architecture, internal reference voltage level (IVREF) and pre-emphasis to overcome conventional operating frequency range are presented. CS_n to command/address latency (CAL), data bus inversion (DBI) and ×4 half-page architecture are introduced to reduce current consumption. Cyclic redundancy check (CRC) and command and address (CA) parity are adopted to check transmission errors in high bandwidth. Also, read CRC with DBI is calculated in parallel to mitigate calculation time and area penalty. Consequently, our 2Gb DDR4 SDRAM achieves 2.4Gb/s data rate at 1.0V supply voltage.Keywords
This publication has 2 references indexed in Scilit:
- Fast parallel CRC & DBI calculation for high-speed memories: GDDR5 and DDR42011
- A 7 Gb/s/pin 1 Gbit GDDR5 SDRAM With 2.5 ns Bank to Bank Active Time and No Bank Group RestrictionIEEE Journal of Solid-State Circuits, 2010