Investigating inexpensive polymeric 3D printed materials under extreme thermal conditions
Open Access
- 16 February 2022
- journal article
- research article
- Published by IOP Publishing in Materials Futures
- Vol. 1 (1) , 015001
Abstract
3D printing is nowadays used for many applications far beyond pure rapid prototyping. As tools to prepare custom-made objects which may be highly complex, different 3D printing techniques have emerged into areas of application where the mechanical, thermal, optical and other properties have to meet high requirements. Amongst them, applications for space, e.g. for microsatellites, make extreme demands regarding the stability under high temperatures. Nevertheless, polymeric 3D printed materials have several advantages for space application in comparison with metal objects. Here we thus investigate the impact of temperatures up to 85 °C and 185 °C, respectively, on typical 3D printing materials for fused deposition modeling or stereolithography (SLA) with inexpensive 3D printers. The materials are found to differ strongly in terms of mechanical properties and dimensional stability after the treatment at a higher temperature, with SLA resins and co-polyester showing the best dimensional stability, while acrylonitrile–butadiene–styrene and SLA resin after long UV post-treatment has the best mechanical properties.Keywords
Funding Information
- Ministry of Culture and Science of the State of North Rhine-Westphalia (Zukunftsfonds)
- Silesian University of Technology Rector’s Grant (14/030/RGJ21/00110)
- German Federal Ministry for Economic Affairs and Energy (KK5129708TA1)
This publication has 26 references indexed in Scilit:
- Novel Materials for 3D Printing by PhotopolymerizationAdvanced Materials, 2018
- High‐Speed 3D Printing of High‐Performance Thermosetting Polymers via Two‐Stage CuringMacromolecular Rapid Communications, 2018
- Influence of thermal processing conditions in 3D printing on the crystallinity and mechanical properties of PEEK materialJournal of Materials Processing Technology, 2017
- Decentralization and Localization of ProductionCalifornia Management Review, 2017
- Possible Applications of 3D Printing Technology on Textile SubstratesIOP Conference Series: Materials Science and Engineering, 2016
- Development of an integrated spacecraft Guidance, Navigation, & Control subsystem for automated proximity operationsActa Astronautica, 2016
- Crystallization behavior and morphological characterization of poly(ether ether ketone)Polymer, 2014
- Development of a Reusable Atomic Oxygen Sensor Using Zinc Oxide Thick FilmsIEEE Sensors Journal, 2013
- Morphological Changes at a Silver Surface Resulting from Exposure to Hyperthermal Atomic OxygenThe Journal of Physical Chemistry C, 2007
- Space environment effects on polymers in low earth orbitNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2003