A Simplified Multi-Linear Spring Model for Cross-Plate Joint in Diaphragm Walls Based on Model Tests
Open Access
Abstract
Cross-plate joints between panels are commonly used in diaphragm wall construction to ensure structural integrity. However, research on the mechanical behaviour of these joints remains limited, and they are often disregarded in numerical modelling due to their complexity. This paper fabricated two types of specimens with cross-plate joints, which were subsequently employed in bending and shear tests, respectively. The load–displacement curves and the joint openings were experimentally measured. It was found that the load–displacement curves exhibited approximately four linear stages in the bending tests and two in the shear tests. Based on the test results, a multi-linear spring model was proposed to simplify the mechanical behaviour of the joints, and the stiffness of each linear stage was determined through back-analysis of the tested data. The calculated load–displacement curves ultimately agreed well with those obtained from the tests, with average errors of 3.6% in the bending test and 2.6% in the shear test. The proposed model was then applied to a devised case study, thereby demonstrating its capacity to capture joint opening phenomena and revealing the spatial variability of joint opening within the excavation depth. Compared with conventional 2D and 3D models, the proposed model yields displacement results that better reflect the actual deformation of the diaphragm wall. Furthermore, the precise modelling calculation for joints, which is time-consuming, is also avoided, and the calculation time of the proposed model is only 1.52 times that of the conventional 3D model.Keywords
Funding Information
- NINGBO COMMONWEAL RESEARCH PROGRAM (2023S131, 2024J094, NZ22GJ007)
- Natural Science Foundation of Ningbo Municipality (2023S131, 2024J094, NZ22GJ007)
- National Scientific Research Project Cultivation Project by Ningbo Polytechnic (2023S131, 2024J094, NZ22GJ007)
This publication has 42 references indexed in Scilit:
- Shaking table test for subway station considering the influence of diaphragm wallsEarthquake Engineering & Structural Dynamics, 2024
- Finite element analysis for a deep excavation in soft clay supported by lime-cement columnsComputers and Geotechnics, 2023
- Experimental investigation and mechanical model for assembled joints of prefabricated two-wall-in-one diaphragm wallsEngineering Structures, 2022
- Numerical evaluation of the perfobond (PBL) shear connector with transverse rebar using coupled rigid Body spring model (RBSM) and solid finite element method (FEM)Structures, 2022
- Corner and partition wall effects on the settlement of a historical building near a supported subway excavation in soft soilComputers and Geotechnics, 2020
- Displacement and force analyses of braced structure of deep excavation considering unsymmetrical surcharge effectComputers and Geotechnics, 2019
- Research on Mechanics of Longitudinal Joint in Shield Tunnel by the Nonlinear Spring Equivalent MethodKSCE Journal of Civil Engineering, 2018
- Vermeidung von Schäden an Schlitzwandfugen durch den Einsatz geeigneter QualitätssicherungssystemeBautechnik, 2015
- Advanced finite element analysis of a complex deep excavation case history in ShanghaiFrontiers of Structural and Civil Engineering, 2014
- Effects from diaphragm wall installation to surrounding soil and adjacent buildingsComputers and Geotechnics, 2013