Batch Reactor Design and Conception at Laboratory Scale for Solid-State Anaerobic Digestion: Practical Comparison Between 3D-Printed Digesters and Conventional Methods

Authors:
Open Access
Publisher website
Google Scholar
Abstract
Solid-state anaerobic digestion (SS-AD) is a promising technology for treating organic waste and producing renewable energy. This study explores the feasibility of using 3D printing to rapidly design cost-effective laboratory-scale digesters for optimization experiments. Batch reactors were designed using fused deposition modeling (FDM) with polylactic acid (PLA) and stereolithography (SLA) with High Temp V2 resin. PLA had a negligible impact on methane yields, while raw SLA resin positively influenced methanogenic potential, likely due to residual isopropanol used in post-processing, causing a 19% increase in CH4 yield. The performance of the 3D-printed reactors was compared to that of a conventionally machined PMMA reactor using cattle manure as a substrate, showing comparable methane yields and process stability. Three-dimensional printing technologies have demonstrated remarkable efficiency in designing laboratory-scale digesters, with a 70% cost reduction for SLA technology and an 80% reduction in design time compared to conventional reactors designed by plastics processing, while maintaining comparable biogas production. FDM technologies with PLA have shown that they are not suitable for these uses. This study demonstrates the potential of additive manufacturing to accelerate SS-AD research and development. However, care must be taken in material selection and post-processing to avoid introducing experimental bias.
Funding Information
  • FEDER (FEDER PO Picardie/MOCOPEE PI0012581)
  • MOCOPEE (FEDER PO Picardie/MOCOPEE PI0012581)

This publication has 36 references indexed in Scilit: