Micro electrical discharge milling of a monocrystalline silicon complex micro-cavity
- 13 September 2021
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 37 (6) , 681-692
Abstract
This paper develops a new method to restrain the fracture of monocrystalline silicon machining in EDM (Electrical discharge machining) through controlling the topography of single discharge crater. By this method, the complex 3D micro-cavity can be machined without obvious fracture. The fracture of monocrystalline silicon in EDM was revealed according to the EDM pits and the machining debris, then it is inferred that there are two ways to cause fractures, one is the breakages at the edge of the effective-removing crater, and the other way is the deformation accumulation caused by the superposition of the ineffective-removing crater. Then, it was found that if the morphology of single discharge crater can be controlled, the less fracture can be guaranteed during the manufacturing. Using narrow pulse width discharge, plenty of experimental tests were carried out focused on carters and surface of monocrystalline silicon with different machining parameters, with the assistance of characterization and analysis. Using these new results, the complex 3D structure is machined by layered compensation strategy and step-by-step milling strategy. It is found from the as-machined complex 3D cavity that it has no obvious defects at the edges, and the fracture is controlled.Keywords
Funding Information
- National Natural Science Foundation of China (grant number 51775145 and 52075130)
- Major Project of Applied Technology Research and Development Plan of Heilongjiang Province (grant number GA16A404)
This publication has 18 references indexed in Scilit:
- Fabrication of ZrB 2 –SiC–graphite ceramic micro-nozzle by micro-EDM segmented millingJournal of Micromechanics and Microengineering, 2018
- An improved fix-length compensation method for electrical discharge milling using tubular toolsInternational Journal of Machine Tools and Manufacture, 2018
- Ultra thin silicon wafer slicing using wire-EDM for solar cell applicationMaterials & Design, 2017
- The effect of pulse energy on the removal form of silicon crystal in electrical discharge machiningMaterials Research Express, 2016
- Surface and subsurface characterisation in micro-milling of monocrystalline siliconThe International Journal of Advanced Manufacturing Technology, 2015
- Micro Three-Dimensional Cavities Tools Fabrication on PCD by µ-EDM Scanning ProcessMaterials and Manufacturing Processes, 2012
- Critical cutting thickness in ultra-precision machining of single crystal siliconThe International Journal of Advanced Manufacturing Technology, 2012
- A multiprocess machine tool for compound micromachiningInternational Journal of Machine Tools and Manufacture, 2010
- Fabrication of compliant high aspect ratio silicon microelectrode arrays using micro-wire electrical discharge machiningMicrosystem Technologies, 2009
- A valveless diffuser/nozzle-based fluid pumpSensors and Actuators A: Physical, 1993