Development of a New Laser Conditioning Method for Ultra-Fine Grit Diamond Wheels
Authors:
- 15 January 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 329, 175-180
Abstract
This paper reports a new laser conditioning method for micro-wheels with ultra-fine grit diamond, which are used for the micro grinding of micro-aspherical optics. Resinoid-bonded micro-wheels with ultra-fine grit diamonds are used for micro grinding. Such small wheels have the problem of poor ground surface roughness due to their few effective cutting edges and low peripheral speeds. In the present work, new truing and dressing methods are proposed to produce many effective cutting edges. The new method uses the third harmonic of a Nd:YAG laser, which is suitable for processing resinoid bond material. It was found that a SD1500B wheel treated using the new method had a higher cutting edge density than one treated using a conventional method, the cup truer method. A good surface roughness was obtained using the new method.Keywords
This publication has 11 references indexed in Scilit:
- Dressing of resin-bonded superabrasive grinding wheels by means of acousto-optic Q-switched pulsed Nd:YAG laserOptics & Laser Technology, 2004
- Wear of diamond dresser in laser assisted truing and dressing of vitrified CBN wheelsInternational Journal of Machine Tools and Manufacture, 2003
- A novel laser-assisted truing and dressing technique for vitrified CBN wheelsInternational Journal of Machine Tools and Manufacture, 2002
- Dressing of Resinoid Bond Wheel with Moving Heat Source (3rd Report)Journal of the Japan Society for Precision Engineering, 1997
- Influence of dressing feed on the performance of laser dressed Al2O3 wheel in wet grindingInternational Journal of Machine Tools and Manufacture, 1995
- Dressing of Resinoid Bond Wheel with Moving Heat Source (2nd Report)Journal of the Japan Society for Precision Engineering, 1995
- Grinding Assisted by Nd:YAG LasersCIRP Annals, 1995
- Dressing of Resinoid Bond Wheel with Moving Heat Source (1st Report)Journal of the Japan Society for Precision Engineering, 1993
- Investigations on Laser Dressing of Grinding Wheels—Part II: Grinding Performance of a Laser Dressed Aluminum Oxide WheelJournal of Engineering for Industry, 1989
- Investigations on Laser Dressing of Grinding Wheels—Part I: Preliminary StudyJournal of Engineering for Industry, 1989