Optimization of SiC Cleaning Process Based on Zeta Potential
Authors:
Open Access
- 19 March 2023
- journal article
- research article
- Published by Darcy & Roy Press Co. Ltd. in Academic Journal of Science and Technology
- Vol. 5 (2) , 158-162
Abstract
This The SiC is a polar semiconductor that is easy to adsorb particles due to the surface charges, which results in that the RCA process commonly used for silicon cleaning is not good for SiC cleaning, and the technique should be optimized. To check the surface charge of SiC wafers during the cleaning process, this work investigated the adsorption of polystyrene spheres (PS) on SiC epitaxial wafers at different pH values and measured the Zeta potential of the SiC wafers. We analyzed the mechanisms by which the Zeta potential in alkaline (SC1) and acidic (SC2) cleaning solutions affects the adsorption of particles on SiC epitaxial wafers surface. The results showed that both the SiC epitaxial wafers and the particles had a negative Zeta potential in the SC1 cleaning solution and there was an electrostatic repulsion between them. In contrast, in the SC2 cleaning solution, the SiC epitaxial wafers and particles had opposite Zeta potentials, which caused attraction between the wafers and particles. Therefore, based on the analysis of Zeta potential, we proposed an optimized the SiC cleaning process that use SC2 cleaning before SC1 cleaning. We successfully reduced the number of particles attached to the surface of SiC epitaxial wafers by 80.4% than RCA cleaning process by the optimized cleaning process. The optimized cleaning process would have a practical value due to the reduction on the consumption of time and chemical reagents.Keywords
This publication has 14 references indexed in Scilit:
- Wetting behavior of water on silicon carbide polar surfacesPhysical Chemistry Chemical Physics, 2016
- Competition between surface modification and abrasive polishing: a method of controlling the surface atomic structure of 4H-SiC (0001)Scientific Reports, 2015
- Microstructure and mechanical properties of aminated polystyrene spheres/epoxy polymer blendsComposites Part A: Applied Science and Manufacturing, 2014
- Cleaning of SiC surfaces by low temperature ECR microwave hydrogen plasmaApplied Surface Science, 2011
- Influence of surface cleaning effects on properties of Schottky diodes on 4H–SiCApplied Surface Science, 2008
- Synthesis of CeO2-coated SiO2 nanoparticle and dispersion stability of its suspensionMaterials Chemistry and Physics, 2008
- SiC Cleaning Method by Use of Dilute HCN Aqueous SolutionsJournal of the Electrochemical Society, 2008
- Study of the temperature-dependent interaction of 4H–SiC and 6H–SiC surfaces with atomic hydrogenApplied Physics Letters, 2004
- Effects of process parameter variations on the removal rate in chemical mechanical polishing of 4H-SiCJournal of Electronic Materials, 2001
- GaN grown on two-step cleaned C-terminated 6H–SiC by molecular-beam epitaxyJournal of Vacuum Science & Technology A, 2001