Effect of Heat Treatment on Deformation Induced Martensite in Austenitic Stainless Steel
Authors:
- 14 May 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 510-511, 214-220
Abstract
Austenitic stainless steel with submicron gain size has been attracted due to fine structural control of mechanical properties. In order to achieve a submicron grain size, meta-stable austenitic steel AISI 304 is severely cold deformed and then annealed to different heat treatment cycles. The heat treated samples were then tested for metallurgical phase change, texture components and hardness. It was observed that at 750°C, all the martensite transformed completely into austenite. Further, at the same temperature, it was observed that the texture component {221} was the dominant texture component.Keywords
This publication has 6 references indexed in Scilit:
- Nanograined/Ultrafine-Grained Structure and Tensile Deformation Behavior of Shear Phase Reversion-Induced 301 Austenitic Stainless SteelMetallurgical and Materials Transactions A, 2010
- Enhanced Mechanical Properties through Reversion in Metastable Austenitic Stainless SteelsMetallurgical and Materials Transactions A, 2009
- Deformation processes during tensile straining of ultrafine/nanograined structures formed by reversion in metastable austenitic steelsScripta Materialia, 2008
- Magnetic characterization of cold rolled and aged AISI 304 stainless steelNDT & E International, 2005
- Overview no. 76Acta Metallurgica, 1988
- A Direct Method of Determining Preferred Orientation of a Flat Reflection Sample Using a Geiger Counter X-Ray SpectrometerJournal of Applied Physics, 1949