Numerical Analysis of Hot Cracking in Laser-Hybrid Welded Tubes
Open Access
- 17 December 2013
- journal article
- research article
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2013, 1-8
Abstract
In welding experiments conducted on heavy wall pipes, the penetration mode (full or partial penetration) occurred to be a significant factor influencing appearance of solidification cracks. To explain the observed phenomena and support further optimization of manufacturing processes, a computational model was developed, which used a sophisticated strategy to model the material. High stresses emerged in the models in regions which showed cracking during experiments. In partial penetration welding, they were caused by the prevention of weld shrinkage due to the cold and strong material below the joint. Another identified factor having an influence on high stress localization is bulging of the weld.Keywords
This publication has 15 references indexed in Scilit:
- Experimental investigation of the hot cracking mechanism in welds on the microscopic scaleFrontiers of Materials Science, 2011
- Prediction of Hot Cracks of T-Joints in Full-Penetration Welding ProcessWelding in the World, 2009
- The Effect of Restraint on Weld Solidification Cracking in AluminiumWelding in the World, 2006
- Development of a hot tear indicator for steel castingsMaterials Science and Engineering: A, 2005
- On the Origin of Weld Solidification Cracking2005
- Thermomechanical finite-element model of shell behavior in continuous casting of steelMetallurgical and Materials Transactions B, 2004
- Two-phase modeling of mushy zone parameters associated with hot tearingMetallurgical and Materials Transactions A, 2000
- A new hot-tearing criterionMetallurgical and Materials Transactions A, 1999
- Simple constitutive equations for steel at high temperatureMetallurgical Transactions A, 1992
- Effect of carbon content on the plastic flow of plain carbon steels at elevated temperaturesMetallurgical Transactions A, 1982