Aluminum Evaporation and Etching for the Front-Side Metallization of Solar Cells
Authors:
- 1 April 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 3 (2) , 702-708
Abstract
In this paper, we report and discuss several strategies to produce solar cell front contacts by full-area metallization and etching (FAME). Our chemically structured contacts consume less expensive silver than screen-printed contacts. As a proof of principle for the FAME approach, we present a 148.6-cm2-sized silicon solar cell that has about 100-μm-wide front-side fingers. These fingers consist of a 15-μm-thick evaporated aluminum layer, supplying the electrical conductance, and a sputtered capping stack (200 nm Ni:V plus 20 nm Ag), providing solderability. The entire metal stack is first deposited on the full area of the solar cells, then locally protected by a wax pattern, and subsequently etched with commercial Ni:V etch and NaOH. The efficiency of the best solar cell is 19.3%, the fill factor is 78%, the open-circuit voltage is 666 mV, and the short-circuit current density is 37.1 mA/cm2.Keywords
This publication has 10 references indexed in Scilit:
- Local rear contacts to silicon solar cells by in-line high-rate evaporation of aluminumSolar Energy Materials and Solar Cells, 2012
- Nickel Silicide Formation Using Excimer Laser AnnealingEnergy Procedia, 2012
- Aluminum-Based Mechanical and Electrical Laser Interconnection Process for Module Integration of Silicon Solar CellsIEEE Journal of Photovoltaics, 2011
- High-efficiency back-junction silicon solar cell with an in-line evaporated aluminum front grid2011
- Inkjet structured EWT silicon solar cells with evaporated aluminum metallization and laser-fired contacts2010
- Industrial PVD metallization for high efficiency crystalline silicon solar cells2009
- Front side metallization of crystalline silicon solar cells using selectively laser drilled contact openings2009
- Hot-melt inkjet as masking technology for back-contacted cells2009
- Minimization of undercutting in electrochemical micromachining of patterned aluminum–copper filmsJournal of Micromechanics and Microengineering, 2006
- Simplified backside-contact solar cellsIEEE Transactions on Electron Devices, 1990