Properties of ceramic injection-moulding formulations
Authors:
- 1 June 1987
- journal article
- Published by Springer Nature in Journal of Materials Science
- Vol. 22 (6) , 2267-2273
Abstract
No abstract availableKeywords
This publication has 9 references indexed in Scilit:
- Properties of ceramic injection moulding formulationsJournal of Materials Science, 1987
- Review: Fabrication of engineering ceramics by injection moulding. I. Materials selectionInternational Journal of High Technology Ceramics, 1986
- Review: Fabrication of engineering ceramics by injection moulding. II. TechniquesInternational Journal of High Technology Ceramics, 1986
- On the layer removal analysis of residual stressJournal of Materials Science, 1985
- Failure processes in elastomers at or near a rigid spherical inclusionJournal of Materials Science, 1984
- Effect of injection pressure and crazing on internal stresses in injection-moulded polystyrenePolymer, 1980
- Residual stresses and aging in injection molded polypropylenePolymer Engineering & Science, 1980
- Influence of high injection pressures on the internal stress level in injection moulded specimensPolymer, 1975
- Prediction of the Viscosity of Multimodal Suspensions from Unimodal Viscosity DataTransactions of the Society of Rheology, 1968