Splat morphology and spreading behavior due to oblique impact of droplets onto substrates in plasma spray coating process
Authors:
- C.W. KangCKC.W. Kang
- H.W. NgHNH.W. Ng
- 1 May 2006
- journal article
- Published by Elsevier in Surface and Coatings Technology
- Vol. 200 (18-19) , 5462-5477
Abstract
No abstract availableKeywords
This publication has 17 references indexed in Scilit:
- Studies of splat morphology and rapid solidification during thermal sprayingInternational Journal of Heat and Mass Transfer, 2001
- Influence of Plasma Spray Parameters on Formation and Morphology of ZrO 2 –8 wt% Y 2 O 3 DepositsJournal of the American Ceramic Society, 2001
- Impact, recoil and splashing of molten metal dropletsInternational Journal of Heat and Mass Transfer, 2000
- Theoretical analysis of spreading and solidification of molten droplet during thermal spray depositionInternational Journal of Heat and Mass Transfer, 1999
- Effects of the spray angle on splat morphology during thermal sprayingSurface and Coatings Technology, 1997
- Evaluation of off-angle thermal spraySurface and Coatings Technology, 1997
- Solidification phenomena in picoliter size solder droplet deposition on a composite substrateInternational Journal of Heat and Mass Transfer, 1997
- Deformation and solidification of a droplet on a cold substrateChemical Engineering Science, 1992
- Integrated fabrication process for solid oxide fuel cells using novel plasma sprayingPlasma Sources Science and Technology, 1992
- Solidification of droplets on a cold surfaceInternational Journal of Heat and Mass Transfer, 1976