A Heat Transfer Model Based on Finite Difference Method for Grinding
Authors:
- 1 June 2011
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 133 (3) , 031001
Abstract
A heat transfer model for grinding has been developed based on the finite difference method (FDM). The proposed model can solve transient heat transfer problems in grinding, and has the flexibility to deal with different boundary conditions. The model is first validated by comparing it with the traditional heat transfer model for grinding which assumes the semiinfinite workpiece size and adiabatic boundary conditions. Then it was used to investigate the effects of workpiece size, feed rate, and cooling boundary conditions. Simulation results show that when the workpiece is short or the feed rate is low, transient heat transfer becomes more dominant during grinding. Results also show that cooling in the grinding contact zone has much more significant impact on the reduction of workpiece temperature than that in the leading edge or trailing edge. The model is further applied to investigate the convection heat transfer at the workpiece surface in wet and minimum quantity lubrication (MQL) grinding. Based on the assumption of linearly varying convection heat transfer coefficient in the grinding contact zone, FDM model is able to calculate convection coefficient from the experimentally measured grinding temperature profile. The average convection heat transfer coefficient in the grinding contact zone was estimated as 4.2 × 105 W/m2-K for wet grinding and 2.5 × 104 W/m2-K for MQL grinding using vitrified bond CBN wheels.Keywords
This publication has 29 references indexed in Scilit:
- Heat transfer model for creep-feed grindingJournal of Materials Processing Technology, 2005
- A thermal model of the wet grinding processJournal of Materials Processing Technology, 2000
- Temperature control in CBN grindingThe International Journal of Advanced Manufacturing Technology, 1996
- Thermal Aspects of Grinding: Heat Transfer to Workpiece, Wheel, and FluidJournal of Heat Transfer, 1991
- Coupled heat transfer to workpiece, wheel, and fluid in grinding, and the occurrence of workpiece burnInternational Journal of Heat and Mass Transfer, 1991
- A Simplified Approach to Workpiece Temperatures in Fine GrindingCIRP Annals, 1990
- A Simple Model for Convective Cooling During the Grinding ProcessJournal of Engineering for Industry, 1988
- Avoidance of Thermal Damage in Grinding and Prediction of the Damage ThresholdCIRP Annals, 1988
- Grinding of metals: Theory and applicationJournal of Applied Metalworking, 1984
- On the Mechanics of the Grinding Process Under Plunge Cut ConditionsJournal of Engineering for Industry, 1966