Low-pressure ethylene/air laminar premixed flames: characterisations and soot diagnostics
Open Access
- 21 January 2023
- journal article
- research article
- Published by Springer Nature in Applied Physics B
- Vol. 129 (2) , 1-15
Abstract
In this work, the structure of laminar premixed ethylene/air flat flames at low pressure are studied experimentally. The aim of the work is to exploit the spatial expansion of laminar 1D flames and advanced laser techniques to better understand the conditions and precursors affecting soot particles inception. Soot volume fraction (fv) profiles were measured using laser-induced incandescence (LII), while spatial distribution of the CH* and C2* radicals was measured using spatially resolved emission spectroscopy. Spatially resolved laser-induced fluorescence has been used to record emission from 2–3 rings, 3–4 rings and > 5 rings. The temperature of soot particles (Ts) was evaluated through fitting the spectrally resolved soot luminosity, while flame gaseous temperature (Tg) was measured using a fine thermocouple. The laminar flow velocity was modeled and used to evaluate the reaction time at each HAB. Taking advantage of the expanded flame structure at low pressure, the profiles of CH*, C2*, soot and temperatures, as a function of the height above the burner, were well resolved. It was found that CH* and C2* chemiluminescence overlap in space. The thickness of CH* layer is larger than that of C2*, and it peaks at slightly different location, CH* appears approximately 1 mm before C2*. The distance between the two peaks decreases linearly with the increase in pressure. The lowest value of the initial soot volume fraction (fv) was 0.19 ppb, measured at pressure 27 kPa. It was found that fv scales with the pressure following a power function of the form fv α Prn, where n is 2.15 ± 0.7. It was observed that, in all the flames investigated, the initial soot particles first appear at a common critical inception temperature, Tinception, of 1465 ± 66 K. It was found that the Tinception is lower than the maximum flame temperature, Tmax, by ~ 45° and appeared ~ 1 mm further than the location of Tmax. Using the Lagrangian quantity dfv/dt and fv, it was possible to reveal the soot growth rate, kSG. At pressure of 27 kPa, the value of kSG was evaluated as 20 s−1.Keywords
All Related Versions
This publication has 49 references indexed in Scilit:
- Measurements of sooting tendency in laminar diffusion flames of n-heptane at elevated pressureCombustion and Flame, 2013
- Experimental study of the structure of laminar premixed flames of ethanol/methane/oxygen/argonCombustion, Explosion, and Shock Waves, 2013
- Pyrene Measurements in Sooting Low Pressure Methane Flames by Jet-Cooled Laser-Induced FluorescenceThe Journal of Physical Chemistry A, 2011
- A study of low-pressure premixed ethylene flame with and without ethanol using photoionization mass spectrometry and modelingProceedings of the Combustion Institute, 2010
- A Study of the Early History of Soot Formation in Various Hydrocarbon Diffusion FlamesCombustion Science and Technology, 1991
- Soot formation in premixed C2H4 flat flames at elevated pressureSymposium (International) on Combustion, 1991
- Measurements about the influence of pressure on carbon formation in premixed laminar C2H4-air flamesSymposium (International) on Combustion, 1988
- Measurements of the structure of sooting laminar diffusion flames at elevated pressuresSymposium (International) on Combustion, 1985
- Investigation of the surface growth of soot in flat low pressure hydrocarbon oxygen flamesSymposium (International) on Combustion, 1985
- Rate of soot growth in atmospheric premixed laminar flamesSymposium (International) on Combustion, 1985