Investigation of rail wheel steel crystallographic texture changes due to modification and thermomechanical treatment
Authors:
Open Access
- 24 April 2015
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 82 (1) , 012107
Abstract
In this work crystallographic texture for a set of rail wheel steel samples with different regimes of thermo-mechanical treatment and with and without modification by system Al-Mg-Si- Fe-C-Ca-Ti-Ce was measured by neutron diffraction. The texture measurements were carried out by using time-of-flight technique at SKAT diffractometer situated at IBR-2 reactor (Dubna, JINR, Russia). The three complete pole figures (110), (200), (211) of ?-Fe phase in 5??5?grid were extracted from a set of 1368 spectra measured for each sample. The samples were cut from rail wheel rim and from transitional zone (between rail wheel hub and wheel disk). It was concluded that the steel modification and some changes in the heat treatment modes of the rail wheels from the experimental (modified) and the conventional (non-modified) steel lead to reorientation of texture component.Keywords
This publication has 4 references indexed in Scilit:
- Potential of full pattern fit methods for the texture analysis of geological materials: implications from texture measurements at the recently upgraded neutron time-of-flight diffractometer SKATJournal of Applied Crystallography, 2014
- Investigation of experimental pole-figure errors by simulation of individual spectraCrystallography Reports, 2007
- The SKAT texture diffractometer at the pulsed reactor IBR-2 at Dubna: experimental layout and first measurementsNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 1998
- Standard Distributions in Texture Analysis Volume 11987