Preliminary Study of New Low-Temperature Hard Abrasion Resistant Fe-P and Fe-P-X (X = C or/and B) Casting Alloys
Open Access
Abstract
This article analyses the as-cast state of practically unknown Fe-P-based cast alloys with or without an addition of carbon and/or boron, cast into a grey cast iron mould. The melting intervals of the alloys were determined by DSC analysis, and the microstructure was characterized by optical and scanning electron microscopy with an EDXS detector. The hardness and microhardness of the alloys were also measured. Their hardness reached values between 52 and 65 HRC depending on chemical composition and microstructure, showing their high abrasion resistance. The high hardness is a consequence of the eutectic and primary intermetallic phases of Fe3P, Fe3C, Fe2B or mixed type. By increasing the concentration of metalloids and combining them, the hardness and brittleness of the alloys were increased. The alloys with predominantly eutectic microstructures were the least brittle. Depending on the chemical composition, the solidus and liquidus temperatures ranged from 954 °C to 1220 °C and were lower than those of the well-known wear-resistant white cast irons.Keywords
Funding Information
- ARRS (Javna agencija za raziskovalno dejavnost Republike Slovenije) (P2-0205, P1-0195)
This publication has 11 references indexed in Scilit:
- A review on relationship between morphology of boride of Fe-B alloys and the wear/corrosion resistant properties and mechanismsJournal of Materials Research and Technology, 2019
- The Effect of Heat Treatment on Properties of Ni–P Coatings Deposited on a AZ91 Magnesium AlloyCoatings, 2019
- CementiteInternational Materials Reviews, 2019
- Statistical Analysis of Vickers Indentation Fracture Toughness of Y-TZP CeramicsTransactions of FAMENA, 2017
- Effects of welding residual stresses and phosphorus segregation on cleavage delamination fracture in thick S355 J2 G3+N steel plateEngineering Failure Analysis, 2014
- Iron-based bulk metallic glassesInternational Materials Reviews, 2013
- Application of Fe-P-B alloys in developing wear-resistant composite materialsJournal of Superhard Materials, 2013
- Effect of phosphorus as an alloying element on microstructure and mechanical properties of pearlitic gray cast ironMaterials Science and Engineering: A, 2007
- Electrochemical preparation of amorphous Fe-P alloysJournal of Applied Electrochemistry, 1988
- Widerstand gegen abrasiven verschleiss und dynamische bruchzähigkeit weisser vanadingusseisenWear, 1983