Adhesive-free adhesion between polytetrafluoroethylene (PTFE) and isobutylene–isoprene rubber (IIR) via heat-assisted plasma treatment
Open Access
- 20 January 2017
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (11) , 6432-6438
Abstract
A polytetrafluoroethylene (PTFE) surface was modified using atmospheric pressure plasma treatment under heating (heat-assisted plasma treatment) to promote its direct adhesion to isobutylene–isoprene rubber (IIR) without any adhesives. Plasma-treated PTFE and unvulcanised IIR were thermally compressed and their adhesion strength was evaluated via a T-peel test. Heat-assisted plasma treatments conducted above 250 °C drastically increased the adhesion strength over 2.0 N mm−1 before IIR failure. The plasma-treated PTFE surface was evaluated using X-ray photoelectron spectroscopy, nanoindentation and scanning electron microscopy. The results of these analyses indicated that the adhesion strength drastically increased because heat-assisted plasma treatment promoted the formation of carbon–carbon crosslinks and/or etching of a weak boundary layer (WBL) on the PTFE surface. This led to the recovery of the WBL in PTFE, which resulted in the prevention of PTFE inter-layer peeling in the WBL. In addition, the estimated lifetime of the surface modification surprisingly exceeded one year.Keywords
Funding Information
- Japan Society for the Promotion of Science (15K05723)
This publication has 36 references indexed in Scilit:
- Plasma-modified polymer surfaces: Characterization using XPSJournal of Electron Spectroscopy and Related Phenomena, 2010
- Investigation into the migration potential of coating materials from cookware productsFood Additives & Contaminants, 2007
- XPS and contact angle study of N 2 and O 2 plasma‐modified PTFE, PVDF and PVF surfacesSurface and Interface Analysis, 2006
- Selected Effect of the Ions and the Neutrals in the Plasma Treatment of PTFE Surfaces: An OES‐AFM‐Contact Angle and XPS StudyPlasma Processes and Polymers, 2005
- Plasma modification of PTFE surfaces. Part I: Surfaces immediately following plasma treatmentSurface and Interface Analysis, 2001
- Plasma modification of PTFE surfaces. Part II: Plasma‐treated surfaces following storage in air or PBSSurface and Interface Analysis, 2001
- Separation of theandcomponents in the C1sphotoemission spectra of amorphous carbon filmsPhysical Review B, 1996
- Correlation between Lewis Acid−Base Surface Interaction Components and Linear Solvation Energy Relationship Solvatochromic α and β ParametersLangmuir, 1996
- Surface Texturing of PTFE Film Using Nonequilibrium PlasmasMacromolecules, 1995
- Plasma processes and adhesive bonding of polytetrafluoroethyleneSurface and Interface Analysis, 1993